Join 60,000+ competitive exam aspirants
11 kV cable after installation should be checked for short duration at a voltage of
110 kV
33 kV
20 kV
11 kV
20 kV
According to the Indian Standard (IS) codes for high voltage power cables, a newly installed 11 kV cable must undergo a high-voltage (HV) pressure test to ensure insulation integrity. For an 11 kV cable, the standard field test involves applying a DC test voltage of approximately 20 kV for a short duration (typically 5-15 minutes) after installation.
According to the Indian Standard (IS) codes for high voltage power cables, a newly installed 11 kV cable must undergo a high-voltage (HV) pressure test to ensure insulation integrity. For an 11 kV cable, the standard field test involves applying a DC test voltage of approximately 20 kV for a short duration (typically 5-15 minutes) after installation.
VtestтАЛтЙИ1.8├ЧVratedтАЛ тАФ Standard empirical formula for DC field testing of underground cables
The insulation test acts as a diagnostic tool to detect manufacturing defects, physical damage during laying, or faulty jointing. By applying a DC voltage significantly higher than the rated system voltage but lower than the factory breakdown voltage, the test ensures that the insulation can withstand transient overvoltages without suffering dielectric puncture. If the insulation has voids or cracks, the high electric stress will cause a leakage current increase or breakdown during the test, preventing failure during actual service.
Field testing is essential to verify the integrity of cable joints and terminations.
DC testing is preferred for field applications due to the portability of test equipment compared to AC resonant sets.
Testing duration is generally limited to 5 to 15 minutes to avoid long-term stress accumulation.
Safety discharge sticks must be used post-test to drain capacitive charge stored in the cable.
Identifies installation defects before commissioning
Reduces the probability of unplanned power outages
Potential for dielectric stress if voltage is applied beyond limits
Requires specialized HV test equipment
Commissioning of new HT cable networks
Routine maintenance of underground power distribution systems
For 11 kV systems, the phase-to-phase voltage is 11 kV; the insulation is designed for this stress plus safety margins.
Option A (110 kV) is excessive and would damage the cable insulation. Option D (11 kV) is insufficient as it does not stress the insulation beyond normal operating conditions to reveal latent defects.
C is correct тАФ An 11 kV cable is subjected to a DC test voltage of 20 kV to verify insulation dielectric strength post-installation.
Always remember that field test voltages for cables are typically DC and range between 1.8 to 2 times the RMS rated voltage, never the peak AC value.