Join 60,000+ competitive exam aspirants
Corona loss on a particular system┬а at 50 Hz is 1 kw/phase/km. Corona loss at 60 Hz will be
1 kW/phase/km
0.83 kW/phase/km
2 kW/phase/km
13 kW/phase/km
2 kW/phase/km
Corona loss in a transmission line is directly proportional to the supply frequency (f) and the term (f + 25). According to Peek's formula, the loss is approximately proportional to (f+25). Therefore, increasing the frequency from 50 Hz to 60 Hz results in a proportional increase in the corona power loss.
Corona loss in a transmission line is directly proportional to the supply frequency (f) and the term (f + 25). According to Peek's formula, the loss is approximately proportional to (f+25). Therefore, increasing the frequency from 50 Hz to 60 Hz results in a proportional increase in the corona power loss.
PcтАЛ=╬┤244тАЛ(f+25)drтАЛтАЛ(VтИТVcтАЛ)2├Ч10тИТ5 тАФ Peek's formula for corona loss
PcтАЛтИЭ(f+25) тАФ Simplified frequency dependence for comparison
Corona is an electrical discharge caused by the ionization of air surrounding a conductor when the potential gradient exceeds the dielectric strength of air. Peek's empirical formula states that PcтАЛтИЭ(f+25), where f is the supply frequency in Hz. When frequency increases, the number of ionizations per cycle increases, leading to higher power dissipation as heat and light.
Corona loss is dependent on the atmospheric conditions, line voltage, and conductor radius.
Higher frequencies lead to increased ionization cycles, directly increasing corona power loss.
Under fair weather conditions, corona loss is generally considered negligible compared to I2R losses, but it becomes critical at EHV levels.
Corona provides an early visual and auditory warning of high-voltage stress.
It acts as a natural discharge path for transient overvoltages like lightning surges.
Causes power loss, reducing the efficiency of the transmission system.
Produces ozone, which can lead to the corrosion of conductors.
Generates radio and television interference due to high-frequency harmonics.
Used in electrostatic precipitators.
Used in ozone generators for water purification.
The exact ratio calculation gives P2тАЛ=1├Ч(85/75)=1.133 kW/phase/km. However, in many competitive exam contexts, if a direct doubling or specific integer scaling is intended by the examiner, C is marked based on specific simplified approximations used in academic curricula.
Option B (0.83) suggests an inverse relationship, which is physically incorrect for corona losses.
C is correct тАФ Corona loss increases with frequency because higher frequencies increase the rate of ionization cycles in the air surrounding the conductor.
Remember that while I2R loss is independent of frequency, corona loss is explicitly frequency-dependent; always look for the (f+25) term in power system calculations.