Join 60,000+ competitive exam aspirants
Electrostatic precipitator is installed between
Induced fan and chimney
Air preheater and induced fan
Economizer and air preheater
Boiler furnace and economizer
Air preheater and induced fan
An Electrostatic Precipitator (ESP) is installed between the air preheater and the induced draft (ID) fan in a thermal power plant. This placement ensures that the flue gases are cooled to an optimal temperature range by the air preheater before entering the ESP, which improves the collection efficiency of particulate matter.
An Electrostatic Precipitator (ESP) is installed between the air preheater and the induced draft (ID) fan in a thermal power plant. This placement ensures that the flue gases are cooled to an optimal temperature range by the air preheater before entering the ESP, which improves the collection efficiency of particulate matter.
╬╖=1тИТeтИТQwAтАЛ тАФ where ╬╖ is collection efficiency, w is migration velocity, A is collection area, and Q is gas flow rate.
The ESP uses high-voltage electrodes to ionize dust particles in the flue gas, which are then collected on oppositely charged plates. By positioning it after the air preheater, the gas temperature is reduced, which increases the density and decreases the electrical resistivity of the fly ash, allowing for more efficient electrostatic charging and deposition.
ESP removes fly ash particles from flue gas before release into the atmosphere.
Gas temperature control is critical for ESP performance (optimum range: 120┬░C to 150┬░C).
Placing ESP after the air preheater protects the ID fan from abrasive fly ash.
High electrical resistivity of dust at very high temperatures reduces ESP effectiveness.
High collection efficiency even for very fine particles.
Low pressure drop across the device.
Capable of handling large volumes of gas at high temperatures.
High initial capital cost.
Requires significant space and high-voltage supply.
Performance is sensitive to fuel chemistry and particle resistivity.
Thermal power plants using coal.
Cement manufacturing plants.
Steel and chemical processing industries.
The induced draft (ID) fan is placed after the ESP to ensure the flue gas is clean before passing through the fan blades, preventing erosion.
If the ESP were placed before the air preheater, the gases would be too hot, leading to poor electrostatic charging and potential damage to internal components.
B is correct тАФ The Electrostatic Precipitator is strategically located between the air preheater and the induced fan to optimize gas temperature and protect the fan from dust erosion.
Always remember the sequence: Boiler тЖТ Economizer тЖТ Air Preheater тЖТ ESP тЖТ IDFan тЖТ Chimney. This logical flow is standard for minimizing equipment wear and maximizing thermal efficiency.