Join 60,000+ competitive exam aspirants
If the back emf in DC motor vanishes suddenly the motor will
burn
run at very high speed
run at a very low speed
start haunting
burn
If the back EMF (EbтАЛ) in a DC motor suddenly vanishes, the armature current (IaтАЛ) rises to a dangerously high value because the internal resistance (RaтАЛ) of the armature is extremely low. This excessive current leads to massive Ia2тАЛRaтАЛ heat dissipation within the windings, causing the insulation to melt and the motor to burn out almost instantaneously.
If the back EMF (EbтАЛ) in a DC motor suddenly vanishes, the armature current (IaтАЛ) rises to a dangerously high value because the internal resistance (RaтАЛ) of the armature is extremely low. This excessive current leads to massive Ia2тАЛRaтАЛ heat dissipation within the windings, causing the insulation to melt and the motor to burn out almost instantaneously.
EbтАЛ=60AP╬жZNтАЛ тАФ Back EMF induced in the armature
IaтАЛ=RaтАЛVтИТEbтАЛтАЛ тАФ Armature current relationship
In a DC motor, the armature current is governed by the equation IaтАЛ=RaтАЛVтИТEbтАЛтАЛ. When the back EMF (EbтАЛ) becomes zero, the equation simplifies to IaтАЛ=RaтАЛVтАЛ. Given that RaтАЛ is designed to be very small for efficiency, the resulting surge current is many times higher than the rated current, leading to thermal failure.
Back EMF acts as a self-regulating mechanism for DC motors.
The armature resistance (RaтАЛ) is typically kept very low to reduce copper losses.
A sudden loss of EbтАЛ is effectively a short-circuit condition across the supply voltage.
This situation is catastrophic because the thermal capacity of the copper windings is exceeded in milliseconds.
Option B (high speed) is incorrect because while a drop in flux causes high speed, a zero back EMF represents a short circuit state, not a simple weakening of the field.
A is correct тАФ The vanishing of back EMF results in a massive surge in armature current, which causes the windings to overheat and burn out immediately.
In DC machine problems, always equate the motor terminal voltage to V=EbтАЛ+IaтАЛRaтАЛ to analyze fault conditions.