Join 60,000+ competitive exam aspirants
In a nuclear reactor, chain reaction is controlled by introducing
Iron rods
Cadmium rods
Graphite rods
Brass rods
Cadmium rods
In a nuclear reactor, the chain reaction is controlled by inserting control rods made of neutron-absorbing materials such as Cadmium or Boron. These rods regulate the neutron population by capturing thermal neutrons, thereby adjusting the fission rate and maintaining the reactor at a steady state (critical condition).
In a nuclear reactor, the chain reaction is controlled by inserting control rods made of neutron-absorbing materials such as Cadmium or Boron. These rods regulate the neutron population by capturing thermal neutrons, thereby adjusting the fission rate and maintaining the reactor at a steady state (critical condition).
k=Neutrons┬аlost┬аor┬аabsorbedNeutrons┬аproducedтАЛ тАФ Effective multiplication factor representing the reactor state.
The fission process in a nuclear reactor relies on a self-sustaining chain reaction where neutrons released by fission cause subsequent fission events. Cadmium rods act as neutron 'sinks' because they possess a very high thermal neutron absorption cross-section. By lowering the rods into the reactor core, more neutrons are absorbed, reducing the multiplication factor (k) to decrease or stop the reaction. Conversely, withdrawing them increases k to raise power output.
Cadmium is chosen for its high capture cross-section for thermal neutrons.
The multiplication factor k is kept at k=1 for a steady-state (critical) operation.
Control rods provide a means of rapid reactor shutdown, known as 'scram'.
Graphite acts as a moderator to slow down neutrons, whereas Cadmium acts as a poison to stop them.
Provides precise control over fission rate.
Enables emergency reactor shutdown (SCRAM).
Allows for power level adjustments based on grid demand.
Mechanical wear and tear of the drive mechanisms.
Risk of rod jamming in high-radiation environments.
Limits the maximum power density in specific reactor zones.
Pressurized Water Reactors (PWR).
Boiling Water Reactors (BWR).
Research reactors.
Boron is also commonly used as a control rod material due to its high neutron absorption efficiency.
Option C (Graphite rods) are used as moderators to slow down neutrons, not to control the reaction speed by absorption.
Iron and Brass are poor neutron absorbers compared to Cadmium and are not used for control rods.
B is correct тАФ Cadmium rods are used to absorb neutrons and control the rate of the chain reaction in a nuclear reactor.
Always distinguish between moderators (e.g., Graphite, Heavy Water) which slow neutrons, and control rods (e.g., Cadmium, Boron) which eliminate excess neutrons.