Join 60,000+ competitive exam aspirants
Sag of transmission line depends on
Span length
Tension in conductor
Weight of conductor
All of above
All of above
The sag of an overhead transmission line is the vertical distance between the highest point of the conductor support and the lowest point on the conductor. It is essentially determined by the mechanical equilibrium between the gravitational load of the conductor, the tension applied to it, and the distance between supports.
The sag of an overhead transmission line is the vertical distance between the highest point of the conductor support and the lowest point on the conductor. It is essentially determined by the mechanical equilibrium between the gravitational load of the conductor, the tension applied to it, and the distance between supports.
S=8Twl2тАЛ тАФ Basic parabolic approximation for sag calculation
The sag is governed by the catenary equation, which describes the shape of a flexible cable suspended between two points. For a span length 'l', conductor weight 'w' per unit length, and tension 'T', the sag 'S' is approximated by the parabolic formula S=8Twl2тАЛ. This indicates that sag is directly proportional to the square of the span length and the weight of the conductor, while being inversely proportional to the tension.
Sag increases as the span length increases (due to gravity acting over a larger distance).
Increasing the conductor weight (e.g., ice loading or wind) increases the total sag.
Higher tension reduces the sag, making the conductor tighter, but requires stronger supports.
Temperature variations cause expansion or contraction, changing both 'w' and 'T', thereby affecting sag.
Provides mechanical clearance from ground.
Prevents excessive tensile stress on the conductor and supporting insulators.
Excessive sag can lead to ground clearance violations.
Low sag (excessive tension) increases the risk of mechanical failure of conductors or towers.
Transmission and distribution line design.
Overhead line routing and tower spotting.
The tension T is usually limited to a fraction of the ultimate tensile strength of the conductor to ensure safety.
If tension exceeds safe limits, the conductor may snap during cold weather or high-wind conditions.
D is correct тАФ The sag is a mechanical equilibrium result dependent on span length, tension, and the weight of the conductor.
Always remember the relation SтИЭl2; if the span length is doubled, the sag becomes four times larger, assuming constant tension and weight.