Join 60,000+ competitive exam aspirants
The capacitance CтВРb between conductor a and b separated by distance D and radius r is
CтВРb = 0.0121/log(r/D) ╬╝F/km
CтВРb = 0.0121/log(D/r) ╬╝F/km
CтВРb = 0.0121log(D/r) ╬╝F/km
CтВРb = 0.0121log(r/D) ╬╝F/km
CтВРb = 0.0121/log(D/r) ╬╝F/km
The capacitance CabтАЛ between two parallel conductors in a single-phase transmission line is derived from the potential difference caused by the charge distribution on the conductors. The value is given by the formula CabтАЛ=log10тАЛ(D/r)0.0121тАЛ╬╝F/km, where D is the distance between the centers of the conductors and r is the radius of the conductor.
The capacitance CabтАЛ between two parallel conductors in a single-phase transmission line is derived from the potential difference caused by the charge distribution on the conductors. The value is given by the formula CabтАЛ=log10тАЛ(D/r)0.0121тАЛ╬╝F/km, where D is the distance between the centers of the conductors and r is the radius of the conductor.
C=ln(D/r)2╧А╧╡0тАЛтАЛF/m
CabтАЛ=log10тАЛ(D/r)0.0121тАЛ╬╝F/km
When a potential difference is applied across two parallel cylindrical conductors, a charge density is induced on the surface. The electric field intensity at any point between the conductors is calculated using Gauss's law. By integrating the field intensity, we find the potential difference VabтАЛ. The capacitance is then defined as the ratio of charge q to potential difference VabтАЛ, resulting in the logarithmic dependency on the ratio of spacing D to radius r.
Capacitance increases as the spacing D decreases for a fixed conductor radius r.
Increasing the conductor radius r increases the capacitance C.
The constant 0.0121 is derived from the conversion of natural logs to base 10 logs and units from Farads per meter to micro-Farads per kilometer.
The effect of earth is often neglected for overhead lines with large separation distances compared to line height.
Provides a simple mathematical model for line shunt parameters.
Essential for calculating charging currents in long transmission lines.
Assumes uniform charge distribution on the conductor surface.
Does not account for the influence of the ground unless using the method of images.
Calculation of shunt admittance in Power System analysis.
Determination of Ferranti effect in long lines.
Design of reactive power compensation equipment.
The natural log formula involves ln(D/r), which is approximately 2.303log10тАЛ(D/r). The factor 0.0121 comes from 2.3032╧А╧╡0тАЛтАЛ├Ч106.
Option D is mathematically incorrect as log(r/D)=тИТlog(D/r), which would result in negative capacitance.
B is correct тАФ The capacitance of a two-wire transmission line is inversely proportional to the logarithm of the ratio of the distance between conductors to the conductor radius.
Always verify if the logarithm is base e (ln) or base 10 (log10тАЛ) when solving transmission line parameter problems, as exam papers often mix these conventions.