Join 60,000+ competitive exam aspirants
A 15 cm diameter orifice discharging from a tank issues out a jet of diameter 12.75 cm diameter at a vena contracta. The coefficient of contraction is ______________.
0.682
0.85
0.62
0.722
0.722
The coefficient of contraction (CcтАЛ) is defined as the ratio of the area of the jet at the vena contracta (acтАЛ) to the area of the orifice (AoтАЛ). Given the diameters, the ratio of areas is equivalent to the square of the ratio of diameters.
The coefficient of contraction (CcтАЛ) is defined as the ratio of the area of the jet at the vena contracta (acтАЛ) to the area of the orifice (AoтАЛ). Given the diameters, the ratio of areas is equivalent to the square of the ratio of diameters.
CcтАЛ=AoтАЛacтАЛтАЛ=(doтАЛdcтАЛтАЛ)2
acтАЛ=4╧АтАЛdc2тАЛ
AoтАЛ=4╧АтАЛdo2тАЛ
As fluid flows through an orifice, the streamlines cannot turn abruptly at the sharp edges, causing the jet to converge to a minimum cross-sectional area known as the vena contracta. This contraction factor accounts for the energy loss and flow restriction inherent in the orifice geometry.
Vena contracta represents the point of maximum jet contraction.
For a standard sharp-edged orifice, the theoretical value of CcтАЛ is approximately 0.61 to 0.65.
The calculation for this problem is CcтАЛ=(1512.75тАЛ)2=(0.85)2=0.7225.
Simple method to determine flow characteristics.
Provides a quantitative measure of flow constriction.
Value depends on the Reynolds number and orifice geometry.
Measurement of diameter at vena contracta is experimentally difficult.
Flow rate measurement in pipelines.
Hydraulic discharge calculations in tanks and reservoirs.
Calculation: (1512.75тАЛ)2=0.852=0.7225.
Option A is incorrect as it is a common misinterpretation.
Option B is the ratio of diameters, not the coefficient of contraction.
D is correct тАФ The coefficient of contraction is calculated as the square of the ratio of the jet diameter at the vena contracta to the orifice diameter, resulting in 0.7225тЙИ0.722.
Always verify if the question asks for the diameter ratio or the area ratio (square of diameter ratio) to avoid errors in coefficient calculations.