Join 60,000+ competitive exam aspirants
A 200 MW steam power plant will consume nearly
1,000 tonnes of coal per day
2,000 tonnes of coal per day
4,000 tonnes of coal per day
7,500 tonnes of coal per day
2,000 tonnes of coal per day
A 200 MW coal-fired thermal power plant typically consumes approximately 2,000 tonnes of coal per day assuming a standard plant efficiency of about 30-35%. This estimate is derived from the net heat rate required to sustain the output power considering the energy content of Indian coal.
A 200 MW coal-fired thermal power plant typically consumes approximately 2,000 tonnes of coal per day assuming a standard plant efficiency of about 30-35%. This estimate is derived from the net heat rate required to sustain the output power considering the energy content of Indian coal.
M=╬╖├ЧCVP├Ч24тАЛ тАФ Mass of coal per day (M in tonnes, P in MW, ╬╖ efficiency, CV in MJ/kg)
╬╖overallтАЛ=╬╖boilerтАЛ├Ч╬╖turbineтАЛ├Ч╬╖genтАЛ тАФ Overall plant efficiency
The coal consumption is determined by the input energy requirement (QinтАЛ) calculated as QinтАЛ=EfficiencyOutputPowerтАЛ. With a 200 MW capacity and a typical plant heat rate, the mass flow rate of coal is determined by m╦Щ=╬╖├ЧCVcoalтАЛPтАЛ, where CVcoalтАЛ is the calorific value of coal used.
Average calorific value of Indian steam coal is roughly 4000-4500 kcal/kg.
Specific coal consumption for older Indian plants is approximately 0.6 to 0.8 kg/kWh.
200 MW capacity translates to 4800 MWh per day at 100% load factor.
High reliability for base load demand.
Utilizes abundant domestic coal reserves.
High carbon footprint and greenhouse gas emissions.
Requires significant logistics for fuel transportation.
Base load power generation for grid stability.
Industrial captive power plants.
Option B (2,000 tonnes) is a standard estimation for a 200 MW plant operating at a capacity factor near 70-80%.
Lower consumption figures would require significantly higher thermal efficiency than standard Rankine cycle plants.
B is correct тАФ A 200 MW steam power plant typically requires around 2,000 tonnes of coal daily to maintain steady-state generation.
Always verify the assumed Calorific Value (CV) of the fuel in such problems, as it is the most sensitive parameter affecting the coal-to-power conversion calculation.