Join 60,000+ competitive exam aspirants
A diesel power plant is generally used as
Base load plant
Peak load plant
Standby plant/emergency plant
Any of above
Standby plant/emergency plant
Diesel power plants have high fuel costs and low thermal efficiency compared to thermal or hydro plants, making them unsuitable for continuous base load generation. Due to their quick starting capabilities and ability to operate independently of external water or grid sources, they are primarily used as standby or emergency power units.
Diesel power plants have high fuel costs and low thermal efficiency compared to thermal or hydro plants, making them unsuitable for continuous base load generation. Due to their quick starting capabilities and ability to operate independently of external water or grid sources, they are primarily used as standby or emergency power units.
╬╖thermalтАЛ=QinтАЛWoutтАЛтАЛ тАФ Thermal efficiency of the cycle
PoutтАЛ=V├ЧI├Чcos╧Х тАФ Electrical power output
The plant utilizes a diesel engine as a prime mover coupled to an alternator. Because diesel fuel is expensive, these plants are kept in a 'ready' state to pick up loads during grid failures (blackouts) or as peak-shaving units for short durations where the high operational cost can be justified by the necessity of immediate power availability.
Quick starting time (usually less than 5 minutes).
High cost of diesel fuel makes base load operation uneconomical.
Easily transportable and modular installation.
Used in hospitals, data centers, and remote locations.
Very quick start-up and pick-up of load.
Low land requirement compared to steam or hydro plants.
Minimal cooling water requirement.
Compact physical size.
High operating cost due to fuel price.
High maintenance and lubrication costs.
Limited capacity for large-scale power generation.
High noise levels and exhaust emissions.
Emergency standby power for critical infrastructure.
Peak load shaving in grid operations.
Remote industrial sites and off-grid mining operations.
Diesel plants are generally limited to capacities below 50 MW.
Base load plants are typically run by Nuclear, Hydro, or Thermal (Coal) units due to low operating costs and high reliability.
Option A is incorrect because diesel fuel is too expensive for continuous base load service.
C is correct тАФ Diesel power plants serve primarily as standby or emergency units due to high fuel costs and the ability to start quickly without grid synchronization.
Always remember: Base Load = High Capital/Low Running Cost (Nuclear/Hydro); Peak/Standby = Low Capital/High Running Cost (Diesel/Gas Turbine).