Join 60,000+ competitive exam aspirants
CRGO steel Laminations are used in the core of the transformer to reduce
Eddy Current loss
Hysteresis loss
both Eddy current and Hysteresis losses
Ohmic loss
both Eddy current and Hysteresis losses
Cold Rolled Grain Oriented (CRGO) steel laminations are used in transformer cores to minimize energy losses. By using thin, laminated sheets, eddy current paths are restricted, and the grain-oriented crystalline structure reduces magnetic domain wall friction, thereby lowering hysteresis loss.
Cold Rolled Grain Oriented (CRGO) steel laminations are used in transformer cores to minimize energy losses. By using thin, laminated sheets, eddy current paths are restricted, and the grain-oriented crystalline structure reduces magnetic domain wall friction, thereby lowering hysteresis loss.
PhтАЛ=╬╖fBmaxxтАЛV тАФ Steinmetz hysteresis loss formula
PeтАЛ=KeтАЛf2Bmax2тАЛt2 тАФ Eddy current loss formula
Eddy current loss is proportional to the square of the lamination thickness (PeтАЛтИЭt2); thus, thinning the core reduces current loop areas. Hysteresis loss is caused by magnetic domain flipping; CRGO steel undergoes a cold-rolling process that aligns the iron crystals (grains) in the direction of the magnetic flux, significantly lowering the area of the B-H hysteresis loop.
CRGO steel possesses a preferred orientation of grains along the rolling direction, providing high permeability and low reluctance.
Lamination thickness is typically kept between 0.23 mm to 0.35 mm to mitigate eddy currents.
The use of silicon (usually ~3%) increases the resistivity of the steel, further reducing eddy current magnitudes.
High magnetic permeability
Reduced magnetostriction and noise
Significant reduction in total core losses (Iron losses)
Directional property: Performance is optimal only when flux follows the rolling direction.
Higher manufacturing cost compared to non-oriented steel.
Distribution and power transformers
High-efficiency electrical machines
Hysteresis loss is dependent on the area of the B-H loop, while Eddy current loss is a result of circulating currents induced by varying magnetic fields (Faraday's Law).
Option D is incorrect because Ohmic loss (Copper loss) occurs in the transformer windings (I2R), not the core.
C is correct тАФ CRGO steel laminations simultaneously address hysteresis loss via high-quality magnetic grain orientation and eddy current loss via material resistivity and physical insulation of layers.
Always remember: Iron losses are independent of load, whereas Ohmic losses vary with the square of the load current (PcuтАЛтИЭI2).