Join 60,000+ competitive exam aspirants
Diverters are used only in DC __________ motor for speed control.
shunt
series
either of these
none of the above
series
Diverters are variable resistors connected in parallel with the series field winding of a DC series motor. They are used to control the motor speed by effectively reducing the flux produced by the field winding, thereby allowing speed control above the rated speed.
Diverters are variable resistors connected in parallel with the series field winding of a DC series motor. They are used to control the motor speed by effectively reducing the flux produced by the field winding, thereby allowing speed control above the rated speed.
NтИЭ╬жEbтАЛтАЛ тАФ Speed of DC motor
╬жтИЭIseтАЛ тАФ Flux proportionality
IseтАЛ=IaтАЛ├ЧRdтАЛ+RseтАЛRdтАЛтАЛ тАФ Field current with diverter
When a diverter resistance (RdтАЛ) is connected in parallel with the series field resistance (RseтАЛ), only a fraction of the armature current (IaтАЛ) flows through the field winding. Since NтИЭ╬ж1тАЛ and ╬жтИЭIfieldтАЛ, reducing the field current increases the speed of the motor. This method is exclusively applicable to DC series motors because the field and armature are in separate series paths that allow for parallel shunting of the field.
Diverters reduce the effective field current, decreasing flux.
Flux reduction causes an increase in motor speed.
This method is used for speed control above base speed.
Commonly employed in traction motors.
Simple and inexpensive implementation
Allows speed control beyond rated value
Results in power loss through the diverter resistor
Reduction in motor torque as flux decreases
Electric Traction systems
Hoists and cranes
Option A is incorrect because shunt motors have field windings connected directly across the supply; shunting the field would create a short circuit.
Option C is incorrect as the construction of shunt motors does not permit the use of diverters.
B is correct тАФ Diverters are specifically used for speed control in DC series motors by shunting the series field winding to decrease flux.
Always remember that field weakening methods (like diverters) increase speed, while armature resistance control methods decrease speed.