Join 60,000+ competitive exam aspirants
For a 400 kV line the number of disc in an insulator string is around
37
31
25
16
25
For a 400 kV transmission line, the number of insulator discs in a string is typically around 23 to 25. This number is determined based on the phase-to-ground voltage, the withstand voltage requirement of an individual disc, and the safety factor against atmospheric conditions like pollution and lightning.
For a 400 kV transmission line, the number of insulator discs in a string is typically around 23 to 25. This number is determined based on the phase-to-ground voltage, the withstand voltage requirement of an individual disc, and the safety factor against atmospheric conditions like pollution and lightning.
N=3тАЛ├ЧVdiscтАЛ├Ч╬╖VlineтАЛтАЛ тАФ where N is the number of discs, VlineтАЛ is the line-to-line voltage, and ╬╖ is string efficiency.
EtotalтАЛ=тИСi=1NтАЛViтАЛ тАФ total voltage across the string is the sum of voltage across individual discs.
Transmission line insulators are designed to withstand normal operating voltage, switching surges, and lightning impulses. The voltage across the string is not distributed uniformly due to shunt capacitance between the insulator discs and the supporting tower structure. The number of discs N is calculated as N=VdiscтАЛ├Ч╬╖VphaseтАЛтАЛ, where ╬╖ is the string efficiency and VdiscтАЛ is the flashover voltage of a single disc.
The number of discs increases linearly with the operating voltage level.
Pollution levels (ESDD - Equivalent Salt Deposit Density) often require higher creepage distance, increasing the disc count.
String efficiency ╬╖ is always less than 100% due to unequal voltage distribution across discs.
A standard disc typically has a diameter of 255 mm and a ball-and-socket connection.
Allows for easy maintenance by replacing individual faulty discs.
Flexible design can be adapted for different voltage levels.
Lower voltage is experienced by discs near the cross-arm compared to those near the conductor.
Prone to flashovers if the insulator surface becomes conductive due to dust or salt deposition.
High Voltage (HV) transmission systems.
Extra High Voltage (EHV) and Ultra High Voltage (UHV) power grids.
For 220 kV systems, the typical number of discs is 14-16.
For 765 kV systems, the number of discs usually ranges from 35-40 per string.
The choice is heavily dependent on the insulation coordination studies performed for specific geographical locations.
C is correct тАФ A 400 kV transmission line system requires approximately 23-25 insulator discs per string to ensure adequate insulation levels against standard operational and transient voltages.
Always remember that for competitive exams, doubling the voltage does not necessarily mean doubling the number of discs, as impulse voltage requirements play a dominant role in EHV/UHV designs.