Join 60,000+ competitive exam aspirants
For a given base voltage and base volt amperes, the per unit impedance value of an element is X. The per unit impedance value of this element when the voltage and volt amperes bases are both doubled will be
0.5X
X
2X
4X
0.5X
The per unit (p.u.) impedance of an element is directly proportional to the base volt-amperes (MVAbaseтАЛ) and inversely proportional to the square of the base voltage (kVbaseтАЛ┬▓). When both bases are doubled, the change in the denominator (square of voltage) outweighs the change in the numerator, resulting in the impedance being halved.
The per unit (p.u.) impedance of an element is directly proportional to the base volt-amperes (MVAbaseтАЛ) and inversely proportional to the square of the base voltage (kVbaseтАЛ┬▓). When both bases are doubled, the change in the denominator (square of voltage) outweighs the change in the numerator, resulting in the impedance being halved.
Zp.u.(new)тАЛ=Zp.u.(old)тАЛ├ЧMVAbase,oldтАЛMVAbase,newтАЛтАЛ├Ч(kVbase,newтАЛkVbase,oldтАЛтАЛ)2
The per unit impedance Zp.u.тАЛ is calculated as Zp.u.тАЛ=(kVbaseтАЛ)2Z╬йтАЛ├Ч(MVAbaseтАЛ)тАЛ. If the new base values are MVAnewтАЛ=2├ЧMVAbaseтАЛ and kVnewтАЛ=2├ЧkVbaseтАЛ, then Zp.u.,newтАЛ=(2├ЧkVbaseтАЛ)2Z╬йтАЛ├Ч2├ЧMVAbaseтАЛтАЛ=42тАЛ├ЧZp.u.,oldтАЛ=0.5X.
Per unit impedance is a dimensionless quantity that simplifies power system calculations.
Changing the MVA base scales the impedance linearly.
Changing the voltage base scales the impedance by the inverse square of the voltage ratio.
Eliminates the need to refer impedance values to different sides of transformers.
Simplifies analysis of complex power networks.
Requires careful conversion when base values change across different parts of a system.
Short-circuit analysis
Load flow studies
Stability analysis in power systems
This calculation is critical for bus impedance matrix formation in power system simulation software.
Option C (2X) is incorrect as it incorrectly considers only the numerator change; Option D (4X) is incorrect as it assumes voltage change doesn't impact the denominator.
A is correct тАФ The per unit impedance scales by the ratio of new MVA base to old MVA base and the square of the ratio of old kV base to new kV base, resulting in a value of 0.5X.
In competitive exams, always remember that voltage in the base impedance formula is squared: ZbaseтАЛ=MVAbaseтАЛ(kVbaseтАЛ)2тАЛ. A small change in voltage base causes a significant change in impedance.