Join 60,000+ competitive exam aspirants
For measuring positive, negative and zero sequence voltages in a system, the reference is taken as
Neutral of the system only
Ground only
For zero sequence neutral and for positive and negative the ground
None of the above
None of the above
In symmetrical component analysis, the sequence voltages (V0тАЛ,V1тАЛ,V2тАЛ) are derived from phase voltages (VaтАЛ,VbтАЛ,VcтАЛ) through a linear transformation matrix. The reference for these measurements is the common point of the three-phase system, which is typically the system neutral for star-connected loads, but the specific 'reference' for sequence components is mathematical rather than a physical grounding point.
In symmetrical component analysis, the sequence voltages (V0тАЛ,V1тАЛ,V2тАЛ) are derived from phase voltages (VaтАЛ,VbтАЛ,VcтАЛ) through a linear transformation matrix. The reference for these measurements is the common point of the three-phase system, which is typically the system neutral for star-connected loads, but the specific 'reference' for sequence components is mathematical rather than a physical grounding point.
V0тАЛ=31тАЛ(VaтАЛ+VbтАЛ+VcтАЛ) тАФ Zero sequence voltage definition
V012тАЛ=31тАЛтАЛ111тАЛ1aa2тАЛ1a2aтАЛтАЛтАЛVaтАЛVbтАЛVcтАЛтАЛтАЛ тАФ Transformation matrix
The transformation V012тАЛ=TтИТ1VabcтАЛ uses the operator a = e^{j120┬░. The zero-sequence voltage V0тАЛ is defined as 31тАЛ(VaтАЛ+VbтАЛ+VcтАЛ). This is fundamentally a mathematical decomposition of phasors relative to the system's star-point (or neutral), and if the system is ungrounded, the neutral voltage is determined by the impedances to ground.
Symmetrical components are a mathematical tool to decouple unbalanced polyphase systems into three independent balanced systems.
The zero-sequence component V0тАЛ represents the average of the three phase voltages relative to the neutral point.
The reference is purely theoretical/mathematical based on the phase-to-neutral voltages; ground is only involved if the neutral is solidly grounded.
Simplifies analysis of unbalanced faults in power systems.
Allows for separate sequence network modeling (Positive, Negative, Zero).
Requires complex number calculation.
Does not inherently describe physical ground path impedance without specific network modeling.
Fault analysis (unsymmetrical faults like LG, LL, LLG).
Relay coordination and protective scheme design.
Option C is incorrect because while zero sequence current flows through the ground in specific fault conditions, the reference for voltage measurement is the system neutral.
The correct reference is the neutral of the star-connected system.
D is correct тАФ The measurement of sequence voltages is a mathematical decomposition relative to the neutral point of the system, not specifically just 'neutral' or 'ground' in the way the options suggest.
Always remember that sequence networks are derived from the neutral, and ground only becomes the reference in the zero-sequence network if the neutral is physically connected to ground through an impedance.