Join 60,000+ competitive exam aspirants
Gas turbine power plants are not widely used
As peak load plants
As standby power plants
As base load plants
In combination with steam power plants
As base load plants
Gas turbine power plants possess high fuel costs and relatively low thermal efficiency compared to large-scale steam or nuclear plants. Due to these operational economics, they are ill-suited for continuous base load operation where the priority is the lowest possible cost per unit of electricity generated.
Gas turbine power plants possess high fuel costs and relatively low thermal efficiency compared to large-scale steam or nuclear plants. Due to these operational economics, they are ill-suited for continuous base load operation where the priority is the lowest possible cost per unit of electricity generated.
╬╖thermalтАЛ=1тИТrp(╬│тИТ1)/╬│тАЛ1тАЛ тАФ Efficiency of the Brayton cycle where rpтАЛ is pressure ratio
PnetтАЛ=m╦Щ(wtтАЛтИТwcтАЛ) тАФ Net power output of the gas turbine unit
Gas turbines operate on the Brayton cycle, involving compression of air, constant pressure heat addition in a combustion chamber, and expansion through a turbine. Because they have a quick startup time (can reach full load in minutes) and relatively lower capital costs, they are ideal for peaking or standby service but become prohibitively expensive for 24/7 base load supply.
Gas turbines have a rapid startup time, making them excellent for peak load management.
The primary disadvantage is the high cost of high-grade fuel (Natural gas or distillate oil).
Base load plants typically require cheap fuel and high efficiency (e.g., Coal, Nuclear, Hydro).
Combined Cycle Gas Turbine (CCGT) plants increase overall efficiency but still focus on intermediate/peak demand.
Quick start-up and shut-down capabilities
Lower capital investment compared to steam power plants
Requires less space and water for operation
Higher fuel cost per kWh generated
Lower overall thermal efficiency in simple cycle mode
Sensitive to ambient air temperature changes
Peak load power supply
Standby and emergency power generation
Combined cycle power generation (CCGT)
| Feature | Gas Turbine | Steam/Nuclear |
|---|---|---|
Efficiency | Lower (Simple Cycle) | Higher (Base Load Plants) |
Base load plants must run at high capacity factors (typically > 70%).
Peak load plants run for short durations (typically < 10% of total annual hours).
C is correct тАФ Gas turbine plants have high operating costs due to fuel consumption, making them uneconomical for constant base load duty.
Always remember the classification by load: Base Load (High capacity, low variable cost), Intermediate (Medium), and Peak Load (Low capacity, fast start, high variable cost).