Join 60,000+ competitive exam aspirants
Gas turbines can be brought to the bus bar from cold in about
2 minutes
30 minutes
1 hour
2 hours
2 minutes
Gas turbines possess an exceptionally fast start-up capability, allowing them to reach full load and synchronize with the grid in approximately 2 minutes from a cold start. This unique feature makes them ideal for peak load operation and emergency standby power generation in electrical power systems.
Gas turbines possess an exceptionally fast start-up capability, allowing them to reach full load and synchronize with the grid in approximately 2 minutes from a cold start. This unique feature makes them ideal for peak load operation and emergency standby power generation in electrical power systems.
WnetтАЛ=WturbineтАЛтИТWcompressorтАЛ тАФ Net work output of the Brayton cycle
╬╖thтАЛ=1тИТrp(╬│тИТ1)/╬│тАЛ1тАЛ тАФ Theoretical thermal efficiency of a gas turbine
Unlike steam turbines which require complex boiler warm-up sequences to manage thermal stresses, gas turbines operate on an open Brayton cycle. Air is compressed, mixed with fuel in the combustion chamber, and the high-energy gas expands through the turbine. Because they have fewer auxiliary components and lower thermal inertia than thermal power plants, the rotor can reach operational speed very quickly without risking structural integrity.
Gas turbines are primarily used as peaking plants due to their rapid response.
The start-up time is significantly lower compared to steam turbines (which take hours).
They use low-inertia components compared to Rankine cycle systems.
Frequent starts and stops do not impose the same level of thermal stress as large steam boilers.
Extremely short synchronization time.
Lower initial capital cost compared to steam/nuclear plants.
High operational flexibility for peaking duty.
Lower overall thermal efficiency compared to combined cycle plants.
High fuel costs due to the requirement for premium fuels (gas or high-grade oil).
Shorter service life if operated continuously at high loads.
Peak load power supply.
Black start capability for power grids.
Emergency standby power generation.
| Feature | Gas Turbine | Steam Turbine |
|---|---|---|
Start-up Time | 2 minutes | 2 - 5 hours |
Steam turbines involve large metal masses in boilers and piping, necessitating a 'soaking' period to prevent thermal fatigue.
The 2-minute figure refers to the 'cold' start capability, where the turbine is at ambient temperature prior to ignition.
A is correct тАФ Gas turbines are designed for high flexibility and can reach full operating speed and load in approximately 2 minutes from a cold state.
Always associate 'Gas Turbine' with 'Peaking Plant' and 'Short Start-up Time', and 'Steam Turbine' with 'Base Load' and 'High Thermal Inertia' for competitive exams.