Join 60,000+ competitive exam aspirants
Greater part of the power developed by the turbine is used in driving the compressor. It is around
75%
65%
45%
35%
65%
In a gas turbine power plant, the turbine generates both useful power and the power required to drive the air compressor. A significant majority of the gross power output of the turbine, typically around 65%, is consumed internally to maintain the compression process, leaving only a fraction as net useful work.
In a gas turbine power plant, the turbine generates both useful power and the power required to drive the air compressor. A significant majority of the gross power output of the turbine, typically around 65%, is consumed internally to maintain the compression process, leaving only a fraction as net useful work.
WnetтАЛ=WturbineтАЛтИТWcompressorтАЛ тАФ The net power available at the shaft
BackWorkRatio(BWR)=WturbineтАЛWcompressorтАЛтАЛтЙИ0.65 тАФ Ratio of compressor work to turbine work
The Brayton cycle, which governs gas turbine operation, requires a compressor to pressurize incoming air before combustion. Because the specific volume of the gas being compressed is high, the work input to the compressor is large. Since the turbine extracts work from the high-pressure, high-temperature gas, a substantial portion of its work is mechanically coupled back to the compressor to sustain the cycle.
The gas turbine power plant requires high internal auxiliary power for air compression.
The net output is the difference between turbine gross work and compressor work.
A higher Back Work Ratio signifies lower net efficiency in the Brayton cycle.
Modern gas turbines aim to reduce this ratio through multi-stage compression and intercooling.
High power-to-weight ratio for the net output
Rapid start-up time compared to steam plants
High parasitic load due to compressor requirements
Sensitive to high ambient air temperatures which increase compressor work
Aircraft jet propulsion
Peaking power plants in electrical grids
The back work ratio is significantly higher in gas turbines than in steam power plants, where the feed pump work is typically less than 1-2% of the turbine output.
If the compressor work is not efficiently managed, the net efficiency of the power plant drops drastically.
B is correct тАФ approximately 65% of the power developed by the turbine is required to drive the compressor, a characteristic defined as the back work ratio.
Always remember that in steam cycles (Rankine cycle), the compressor/pump work is negligible compared to turbine work, whereas in gas cycles (Brayton cycle), it is the dominant parasitic load.