Join 60,000+ competitive exam aspirants
In a steam turbine cycle, the lowest pressure occurs in
Condenser
Turbine inlet
Boiler
Super heater
Condenser
In a Rankine cycle (steam turbine cycle), the lowest pressure occurs in the condenser. The condenser maintains a vacuum or near-vacuum state to maximize the enthalpy drop across the turbine, thereby increasing cycle efficiency.
In a Rankine cycle (steam turbine cycle), the lowest pressure occurs in the condenser. The condenser maintains a vacuum or near-vacuum state to maximize the enthalpy drop across the turbine, thereby increasing cycle efficiency.
WnetтАЛ=WturbineтАЛтИТWpumpтАЛ тАФ Net work output of the cycle
╬╖thermalтАЛ=1тИТQinтАЛQoutтАЛтАЛ тАФ Thermal efficiency of the cycle
Steam exiting the turbine is condensed into liquid by extracting latent heat using cooling water. By condensing the steam, its volume decreases drastically, creating a low-pressure zone (vacuum) that acts as a 'sink' for the turbine exhaust, enabling expansion to continue to a pressure well below atmospheric levels.
Condenser pressure is typically much lower than atmospheric pressure (sub-atmospheric).
The vacuum is maintained by the phase change from steam to liquid water, causing a massive reduction in specific volume.
Lowering the condenser pressure shifts the bottom of the Rankine cycle to the left on a T-s diagram, increasing the area under the curve (net work).
Increases the enthalpy drop across the turbine
Increases overall thermal efficiency
Recovers feed water for reuse in the boiler
Requires significant cooling water infrastructure
Risk of air leakage into the system requiring vacuum pumps (ejectors)
Thermal power plants
Nuclear power plants
Marine propulsion systems
Condenser pressure is generally kept between 0.05 to 0.1 bar.
Option B (Turbine inlet) is the highest pressure point in the system.
Option C (Boiler) is a high-pressure zone where heat is added to the working fluid.
A is correct тАФ The condenser operates at the lowest pressure in a steam turbine cycle to maximize the work extracted from the steam expansion.
In any vapor power cycle, always look for the component where latent heat is rejected (Condenser) to identify the minimum pressure point.