Join 60,000+ competitive exam aspirants
Increase in condenser back pressure will lead to a
Loss
Gain
None of above
Can not say anything
Loss
An increase in condenser back pressure implies an increase in the saturation temperature of the steam at the condenser. This reduces the enthalpy drop across the turbine, directly resulting in a loss of cycle efficiency and overall power output.
An increase in condenser back pressure implies an increase in the saturation temperature of the steam at the condenser. This reduces the enthalpy drop across the turbine, directly resulting in a loss of cycle efficiency and overall power output.
WnetтАЛ=m╦Щ(h1тАЛтИТh2тАЛ) тАФ where h2тАЛ is the enthalpy at the turbine exit, which increases as back pressure rises.
╬╖thтАЛ=QinтАЛWnetтАЛтАЛ тАФ efficiency decreases as WnetтАЛ decreases.
In a steam power plant, the turbine expands steam down to the condenser pressure (back pressure). By the Rankine cycle, the thermal efficiency ╬╖=1тИТTsupplyтАЛTrejectтАЛтАЛ depends on the sink temperature. If back pressure rises, the condensation temperature increases, raising the heat rejection temperature TrejectтАЛ, which inherently reduces the net work output and thermal efficiency.
Condenser back pressure is the absolute pressure inside the condenser.
Lower back pressure (vacuum) is desired to maximize the expansion of steam.
An increase in back pressure is often caused by cooling water temperature rise or air leakage.
High back pressure can lead to excessive moisture in the last stages of the turbine.
Monitoring back pressure helps in early detection of condenser fouling.
Optimization leads to significant fuel savings in large thermal plants.
Increased back pressure reduces the load-carrying capacity of the turbine.
Higher steam consumption for the same electrical output.
Steam power plant performance monitoring.
Turbine operation and maintenance scheduling.
Ideally, a condenser should operate at the lowest possible pressure corresponding to the cooling water inlet temperature.
Option B (Gain) is incorrect because an increase in back pressure always reduces the usable energy of the steam cycle.
A is correct тАФ An increase in condenser back pressure reduces the enthalpy drop in the turbine, leading to a decrease in thermodynamic efficiency and total power generation.
Always remember that in steam cycles, lower back pressure (higher vacuum) is synonymous with higher efficiency; hence, any rise in pressure is always a 'Loss' for the system.