Join 60,000+ competitive exam aspirants
In bleeder turbines, part of the steam is extracted for
Condensation
Reheating
Feed water heating
Secondary air heating
Feed water heating
Bleeder turbines, also known as extraction turbines, are designed to allow a portion of steam to be extracted at one or more stages before it reaches the condenser. This extracted steam is primarily utilized for regenerative feed water heating in a Rankine cycle.
Bleeder turbines, also known as extraction turbines, are designed to allow a portion of steam to be extracted at one or more stages before it reaches the condenser. This extracted steam is primarily utilized for regenerative feed water heating in a Rankine cycle.
╬╖regenтАЛ=1тИТQinтАЛQoutтАЛтАЛ тАФ representing the thermal efficiency increase via regeneration
╬ФT=TsatтАЛтИТTfeedтАЛ тАФ representing the temperature rise achieved by bleeding steam
In a regenerative cycle, steam is bled from the turbine and mixed with the cold feed water in a Feed Water Heater (FWH). By raising the temperature of the feed water before it enters the boiler, the amount of heat required to convert water to steam in the boiler is reduced, thereby significantly increasing the overall thermal efficiency of the power plant.
Increases the mean temperature of heat addition.
Reduces the mass flow rate through the final turbine stages.
Improvement in thermal efficiency is proportional to the number of heaters used.
Requires complex piping and additional hardware like feed water heaters.
Improved cycle thermal efficiency
Reduced thermal stress on the boiler due to hotter input feed water
Lower moisture content in the low-pressure stages of the turbine
Increased complexity of the steam plant
High capital cost due to additional heat exchangers and piping
Decreased power output for a given boiler size
Large-scale thermal power stations
Cogeneration systems
Marine propulsion turbines
Option A (Condensation) is the function of the condenser, not the extraction point.
Option B (Reheating) involves sending steam back to the boiler, not diverting it to a heater.
Option D (Secondary air heating) is typically performed by economizers or air preheaters using flue gases, not bleeder steam.
C is correct тАФ Bleeder turbines extract a portion of steam to perform regenerative feed water heating, which improves the cycle efficiency.
Always remember that in regenerative cycles, the bleed steam is used to heat feed water, whereas in reheat cycles, the steam is sent back to the boiler to increase its temperature to maintain steam quality.