Join 60,000+ competitive exam aspirants
In high head hydro-electric power plant, the velocity of water flow in penstock is around
m/s
m/s
m/s
10 m/s
m/s
In high head hydro-electric power plants, the velocity of water in the penstock typically ranges between 3 m/s and 6 m/s. Maintaining this velocity range is crucial to balance the cost of the penstock material (which decreases with smaller diameter/higher velocity) and the head loss (which increases with the square of velocity).
In high head hydro-electric power plants, the velocity of water in the penstock typically ranges between 3 m/s and 6 m/s. Maintaining this velocity range is crucial to balance the cost of the penstock material (which decreases with smaller diameter/higher velocity) and the head loss (which increases with the square of velocity).
hfтАЛ=2gDfLv2тАЛ тАФ Darcy-Weisbach head loss equation
P=╬╖╧БgQH тАФ Power output equation involving flow and head
The penstock acts as a conduit to carry water from the surge tank to the turbine. The head loss (hfтАЛ) in the penstock is governed by the Darcy-Weisbach equation: hfтАЛ=2gDfLv2тАЛ. Higher velocities lead to greater frictional losses and increased risk of water hammer effect upon sudden load rejection, requiring careful design optimization.
High head plants utilize longer, narrower penstocks compared to low head plants.
Higher velocity reduces the diameter required, saving on capital costs for steel pipes.
Excessive velocity leads to severe water hammer pressure, threatening pipe structural integrity.
Velocity is restricted to avoid cavitation and excessive turbulence at the turbine inlet.
Reduction in material costs (smaller pipe diameter)
Efficient energy transfer for high potential heads
Increased frictional head loss
Higher risk of water hammer transients
Requirement for high-strength steel alloys
Impulse turbines (Pelton wheels)
High-head reaction turbines (Francis turbines)
Option D (10 m/s) is generally considered too high for standard penstock design due to exponential increases in frictional losses and potential for damaging water hammer effects.
In low head plants, the velocity is typically lower, often in the range of 1-3 m/s.
A is correct тАФ The standard velocity of water in the penstock for high head power plants is typically maintained between 3 m/s and 6 m/s.
Always remember that in hydraulic system design, velocity is inversely proportional to the square of the diameter; increasing velocity reduces material costs but increases power loss via friction.