Join 60,000+ competitive exam aspirants
In the feed water and steam circuit of a thermal power plant, the condensate flows from the condensate extraction pump to the boiler feed pump and then to the boiler. The HP and LP heaters are located in this circuit in relation to the boiler feed pump (BFP) as
Both HP and LP heaters after BFP
HP heater before and, LP heater after BFP
Both HP and LP heaters before BFP
LP heater before and, HP heater after BFP
LP heater before and, HP heater after BFP
In a thermal power plant, the condensate extraction pump (CEP) moves water through Low Pressure (LP) heaters first. The Boiler Feed Pump (BFP) then elevates the pressure of the feedwater, forcing it through the High Pressure (HP) heaters before it enters the boiler drum.
In a thermal power plant, the condensate extraction pump (CEP) moves water through Low Pressure (LP) heaters first. The Boiler Feed Pump (BFP) then elevates the pressure of the feedwater, forcing it through the High Pressure (HP) heaters before it enters the boiler drum.
WnetтАЛ=WtтАЛтИТWpтАЛ тАФ Net work output where WpтАЛ is pump work
╬╖thermalтАЛ=1тИТQinтАЛQoutтАЛтАЛ тАФ Carnot efficiency efficiency foundation
The placement of heaters relative to the BFP is dictated by the pressure requirements of the components. LP heaters operate at low pressures (vacuum or low gauge pressure) to recover heat from turbine bleeds without requiring heavy-duty casings. The BFP acts as the high-pressure boundary, requiring the downstream HP heaters to be constructed with thick, robust walls to withstand boiler-level feed pressures.
LP heaters use extraction steam from the low-pressure stages of the turbine.
BFP is the highest pressure point in the feedwater circuit.
HP heaters use high-pressure extraction steam to maximize thermal efficiency.
Placement ensures the BFP does not have to handle high-temperature water (which might cause cavitation) before the pump inlet.
Improved thermal efficiency through regenerative heating
Reduction in thermal stress on boiler tubes due to higher inlet feed temperature
Prevents thermal shock in the boiler drum
Increased complexity of piping and control valves
Higher initial capital expenditure for multiple heater stages
Supercritical and subcritical thermal power plants
Combined cycle power plants (Heat Recovery Steam Generators)
The deaerator is typically placed between the LP and HP heater strings to remove dissolved oxygen from the feedwater.
Option A is incorrect as the BFP must be protected from high-temperature fluctuations and HP stage pressure.
D is correct тАФ The LP heaters are positioned before the boiler feed pump to operate at lower pressure, while the HP heaters are positioned after the pump to handle high-pressure feedwater.
Remember that pumps are usually placed at the coldest point of the cycle to minimize the specific volume of the working fluid and prevent cavitation.