Join 60,000+ competitive exam aspirants
It is necessary to heat water before feeding it back to the boiler as because of this
The dissolved oxygen and carbon dioxide which would otherwise corrode boiler are removed in the feed water heater
Thermal stresses due to cold water entering the boiler drum are avoided
Some other impurities carried by steam and condensate due to corrosion in boiler and condenser are precipitated outside the boiler
All of above
All of above
Pre-heating feed water in a boiler system is a critical thermodynamic and maintenance practice. It serves to reduce thermal shock, improve cycle efficiency, and mitigate chemical-induced corrosion within the boiler pressure parts.
Pre-heating feed water in a boiler system is a critical thermodynamic and maintenance practice. It serves to reduce thermal shock, improve cycle efficiency, and mitigate chemical-induced corrosion within the boiler pressure parts.
╬╖thermalтАЛ=QinтАЛWnetтАЛтАЛ тАФ Increasing feed temperature reduces QinтАЛ required per unit of steam produced.
The feed water heater uses bleed steam or waste heat to increase the enthalpy of the inlet water. By elevating the temperature to near-saturation conditions, dissolved gases like O2тАЛ and CO2тАЛ (which cause pitting and acidic corrosion) are expelled via deaeration. Additionally, reducing the temperature gradient between the incoming feed and the boiler drum water minimizes the risk of fatigue-related thermal stress failures at connection points.
Dissolved oxygen acts as an electrochemical oxidizing agent.
Carbon dioxide forms carbonic acid, lowering pH and increasing corrosive potential.
Thermal stress is proportional to the temperature gradient ╬ФT=TboilerтАЛтИТTfeedтАЛ.
Pre-heating improves the overall Rankine cycle efficiency.
Increases overall plant thermal efficiency
Reduces maintenance costs due to corrosion
Prevents thermal fatigue of boiler drums
Increased capital cost for feed water heaters
Added complexity to the plant piping and control systems
Thermal power plants
Industrial high-pressure steam boilers
Deaerators are specific types of feed water heaters designed to reduce dissolved oxygen to levels below 0.005 ml/l.
Thermal stress is a function of the coefficient of thermal expansion of the boiler steel; sudden temperature changes cause localized plastic deformation.
D is correct тАФ Heating the feed water simultaneously prevents corrosion through deaeration, minimizes dangerous thermal stresses, and facilitates the removal of impurities.
In power systems exams, always link 'pre-heating' with 'efficiency increase' and 'maintenance cost reduction'; it is a standard design optimization goal.