Join 60,000+ competitive exam aspirants
Low power factor has a drawback of
Increased transmission and distribution losses
Poor voltage regulation
High cost of equipment for given load
All of above
All of above
A low power factor (pf) implies a high reactive power component in the circuit, which necessitates higher current for the same active power. This increased current leads to higher ohmic losses, voltage drops, and requires larger equipment ratings to handle the apparent power.
A low power factor (pf) implies a high reactive power component in the circuit, which necessitates higher current for the same active power. This increased current leads to higher ohmic losses, voltage drops, and requires larger equipment ratings to handle the apparent power.
P=VIcos╧Х тАФ Real Power (Watts)
I=Vcos╧ХPтАЛ тАФ Relationship between current and Power Factor
PlossтАЛ=I2R тАФ Transmission line losses
Since active power P=VIcos╧Х, for a constant load P and voltage V, the current I is inversely proportional to the power factor cos╧Х. As cos╧Х decreases, I must increase. This higher current magnitude leads to increased I2R line losses, higher voltage drops across system impedance (VdropтАЛтЙИI(Rcos╧Х+Xsin╧Х)), and forces generators, transformers, and cables to be sized for higher apparent power (S=VI in kVA).
Low power factor increases the required kVA rating of electrical machines.
Higher currents cause greater voltage drops, leading to poor voltage regulation at the load end.
Higher currents increase copper losses (I2R) in transmission and distribution networks.
Power factor improvement is typically achieved using shunt capacitor banks.
Improved voltage regulation
Reduced transmission/distribution losses
Optimal utilization of existing electrical equipment
Reduced electricity tariffs (incentives)
Increased capital expenditure for power factor correction equipment
Potential for over-correction leading to leading power factor (if not controlled)
Industrial motor installations
Power systems containing large inductive loads like transformers and induction motors
A lagging power factor is primarily caused by inductive loads like induction motors and fluorescent lighting ballasts.
Option B (Poor voltage regulation) occurs because the inductive current drops voltage across the feeder reactance.
Option C (High cost) refers to the fact that transformers and cables must be designed for higher kVA (Apparent Power) rather than just kW (Real Power).
D is correct тАФ All listed options are direct consequences of a low power factor which increases the line current for a given real power demand.
Always remember that low power factor is a consequence of 'lagging' reactive power (Q); improving it essentially means neutralizing Q using capacitors to provide leading reactive power.