Join 60,000+ competitive exam aspirants
Many resistors connected in series will?
Divide the voltage proportionally among all the resistors
Divide the current proportionally
Increase the source voltage in proportion to the values of the resistors
Reduce the power to zero
Divide the voltage proportionally among all the resistors
In a series circuit, resistors are connected end-to-end such that the same current flows through all of them. According to Kirchhoff's Voltage Law (KVL), the total source voltage is distributed across each resistor proportional to its resistance value.
In a series circuit, resistors are connected end-to-end such that the same current flows through all of them. According to Kirchhoff's Voltage Law (KVL), the total source voltage is distributed across each resistor proportional to its resistance value.
VnтАЛ=VtotalтАЛтЛЕReqтАЛRnтАЛтАЛ тАФ Voltage division rule for series circuits
ReqтАЛ=R1тАЛ+R2тАЛ+...+RnтАЛ тАФ Equivalent resistance in series
Since the current I is constant throughout a series path, the voltage drop across any individual resistor RnтАЛ is given by VnтАЛ=I├ЧRnтАЛ by Ohm's Law. Because the total resistance is ReqтАЛ=тИСRnтАЛ, the total voltage VsourceтАЛ=I├ЧReqтАЛ is partitioned such that larger resistors consume a proportionally larger share of the total voltage.
Current is identical in all series components (ItotalтАЛ=I1тАЛ=I2тАЛ=...=InтАЛ).
Total resistance is the algebraic sum of individual resistances.
Voltage across a resistor is directly proportional to its resistance.
Used to create voltage dividers
Current control using series resistors
Failure of one component breaks the entire circuit
Increased total resistance limits total current
Voltage divider circuits
Current limiting for LEDs
Potentiometers
Option B is incorrect because current remains constant in a series circuit; parallel circuits divide current.
Option C is incorrect because resistors do not increase the source voltage; they only dissipate energy.
Option D is incorrect as resistors dissipate power as heat (P=I2R), not reduce it to zero.
A is correct тАФ Resistors in series act as a voltage divider where the total source voltage is distributed proportionally to the individual resistances based on Ohm's Law.
Always remember that in series, current is common (series = same), whereas in parallel, voltage is common (parallel = potential equality).