Join 60,000+ competitive exam aspirants
Presence of sulphur content in coal will cause
Spontaneous combustion during coal storage and sir heater corroding
Clinkering and slagging
Facilitating ash precipitation
All of above
All of above
Sulphur in coal is highly undesirable as it acts as an impurity that promotes chemical degradation and operational inefficiencies. During combustion and storage, sulphur reacts to form compounds that are corrosive to power plant equipment and problematic for boiler maintenance.
Sulphur in coal is highly undesirable as it acts as an impurity that promotes chemical degradation and operational inefficiencies. During combustion and storage, sulphur reacts to form compounds that are corrosive to power plant equipment and problematic for boiler maintenance.
FeS2тАЛ+O2тАЛтЖТFexтАЛOyтАЛ+SO2тАЛ тАФ Oxidation of pyrites causing heat/combustion
SO3тАЛ+H2тАЛOтЖТH2тАЛSO4тАЛ тАФ Formation of corrosive sulfuric acid
During combustion, sulphur reacts with oxygen to form SO2тАЛ and SO3тАЛ. SO3тАЛ reacts with water vapor to form sulfuric acid (H2тАЛSO4тАЛ), which condenses on cooler surfaces like air preheaters, causing severe corrosion. Furthermore, iron pyrites (FeS2тАЛ) in coal promote spontaneous combustion during storage by reacting with oxygen and moisture. Sulphur also lowers the fusion temperature of ash, promoting the formation of 'clinkers' (fused ash masses) and 'slagging' on boiler tubes, which reduces heat transfer efficiency.
Sulphur content typically ranges from 0.5% to 5% in coal.
Higher sulphur content significantly decreases the ash fusion temperature.
Corrosion in air preheaters occurs when flue gas temperatures drop below the acid dew point.
Spontaneous combustion risk increases with finely powdered coal and high pyrite content.
None (Sulphur is considered an undesirable impurity)
Increases equipment maintenance costs due to corrosion
Causes environmental pollution (SOxтАЛ emissions)
Increases slagging tendency on boiler heat transfer surfaces
Thermal Power Plant Fuel Quality Management
Boiler Design Specification
The presence of sulphur necessitates flue gas desulphurization (FGD) systems in modern power plants to meet environmental standards.
Clinkering is the fusion of ash into solid masses that can block the grate or furnace exit.
D is correct тАФ The presence of sulphur leads to spontaneous combustion in storage due to pyrites, corrosion in air heaters due to sulphuric acid, and slagging/clinkering in the boiler.
Always remember that impurities in coal like sulphur and high ash content reduce the boiler efficiency and increase the 'Life Cycle Cost' of the power plant equipment.