Join 60,000+ competitive exam aspirants
Reheat factor in steam turbines depends on
Stage efficiency
Exit pressure
Initial pressure and temperature
All of above
All of above
The Reheat Factor (RF) is defined as the ratio of the cumulative heat drop across all stages of a steam turbine to the total isentropic heat drop from initial state to exhaust pressure. Because the reheating effect caused by internal friction and windage losses in each stage slightly increases the steam quality for the subsequent stage, the Reheat Factor is always greater than unity and depends on the expansion efficiency, pressure ratio, and fluid properties.
The Reheat Factor (RF) is defined as the ratio of the cumulative heat drop across all stages of a steam turbine to the total isentropic heat drop from initial state to exhaust pressure. Because the reheating effect caused by internal friction and windage losses in each stage slightly increases the steam quality for the subsequent stage, the Reheat Factor is always greater than unity and depends on the expansion efficiency, pressure ratio, and fluid properties.
RF=╬Фhis,totalтАЛтИСi=1nтАЛ╬Фhis,iтАЛтАЛ тАФ Definition of Reheat Factor
╬ФhactualтАЛ=RF├Ч╬╖internalтАЛ├Ч╬Фhis,totalтАЛ тАФ Relationship with total isentropic heat drop
In a multi-stage turbine, the losses (friction, turbulence) in an upper stage manifest as an increase in enthalpy of the steam entering the lower stages. This results in the 'reheat' effect. The magnitude of this effect is a function of the stage efficiency (which dictates the entropy increase), the total pressure range of the expansion, and the state of the steam (initial temperature and pressure).
Reheat factor is always greater than 1.0.
It accounts for the benefit obtained from the internal losses of preceding stages.
Higher stage efficiency typically leads to a lower reheat factor.
It is a correction factor applied to multi-stage turbines.
Allows for more accurate estimation of turbine output power.
Helps in predicting the actual enthalpy at turbine exhaust.
Adds complexity to the thermodynamic design calculations.
Dependent on highly specific stage-by-stage efficiency data.
Design of multi-stage steam turbines.
Performance analysis of thermal power plants.
The Reheat Factor typically ranges between 1.02 and 1.06 in large power turbines.
Option B (Exit pressure) influences the total enthalpy drop, thus directly affecting the RF.
D is correct тАФ The reheat factor accounts for cumulative entropy increase and is inherently dependent on stage efficiency, the total pressure range, and initial steam conditions.
Remember that in multi-stage expansion, the 'reheat' is not an external process but an internal thermodynamic gain, hence it is always > 1.