Join 60,000+ competitive exam aspirants
A current of 2┬аA flows through a wire when the two ends of the wire are maintained at a potential difference of 4┬аV. The resistance of the wire will be:
4┬а╬й
21тАЛ┬а╬й
8┬а╬й
2┬а╬й
2┬а╬й
The resistance of a wire is calculated using Ohm's Law, which states that resistance is the ratio of potential difference to the current flowing through it. By dividing the potential difference of 4┬аV by the current of 2┬аA, we determine that the resistance is 2┬а╬й.
The resistance of a wire is calculated using Ohm's Law, which states that resistance is the ratio of potential difference to the current flowing through it. By dividing the potential difference of 4┬аV by the current of 2┬аA, we determine that the resistance is 2┬а╬й.
Think of voltage as the water pressure in a pipe and current as the flow of water; resistance is like a narrow section of the pipe that restricts the flow. The harder it is to push the water through (higher resistance), the less flow you get for a given pressure.
V=I├ЧR тАФ Ohm's Law
R=IVтАЛ тАФ Formula for Resistance
Ohm's Law expresses the linear relationship between voltage (V), current (I), and resistance (R) in an ohmic conductor. It states that V=I├ЧR. Rearranging this formula to solve for resistance gives R=IVтАЛ. Substituting the given values, R=2┬аA4┬аVтАЛ=2┬а╬й.
Ohm's Law is applicable for ohmic conductors.
The SI unit of resistance is the Ohm (╬й).
Voltage and current are directly proportional in a resistor at constant temperature.
Easy calculation for linear electrical components.
Not applicable to non-ohmic devices like diodes where the relationship is not linear.
Circuit design
Determining component ratings in electronics
Ohm's Law is only valid if the temperature of the conductor remains constant.
Option D is 2┬а╬й, which matches the calculation 4/2.
D is correct тАФ The resistance is calculated as R=IVтАЛ=24тАЛ=2┬а╬й.
Always ensure units are in standard SI (Volts, Amperes) before applying Ohm's Law. If units were in millivolts or milliamperes, convert them first!