Join 60,000+ competitive exam aspirants
Which of the following is NOT the correct relation between electric power (P), electric current (I), electric potential difference (V) and resistance (R):
P=RV2тАЛ
P=VI
P=I2R
P=IR
P=IR
Electric power (P) is defined as the rate at which work is done or energy is dissipated in an electric circuit. The relationship P=IR is incorrect as it represents Ohm's Law (where V=IR), whereas the correct relations are P=VI, P=I2R, and P=RV2тАЛ.
Electric power (P) is defined as the rate at which work is done or energy is dissipated in an electric circuit. The relationship P=IR is incorrect as it represents Ohm's Law (where V=IR), whereas the correct relations are P=VI, P=I2R, and P=RV2тАЛ.
Think of voltage as the water pressure pushing through a pipe and current as the flow of water; power is the total energy delivered by that water flow to turn a turbine, which depends on both the pressure and the amount of water flowing.
P-IV (Power = I times V), or remember the 'P' trio: 'PIV', 'PIR squared', and 'P is V squared over R'.
P=VI тАФ Power in terms of Voltage and Current
P=I2R тАФ Power in terms of Current and Resistance
P=RV2тАЛ тАФ Power in terms of Voltage and Resistance
The power in a resistive circuit is derived from the work done by the potential difference (V) to move charges (I). Since V=IR from Ohm's law, we can substitute this into the fundamental power formula P=VI. Substituting V=IR gives P=(IR)I=I2R, and substituting I=RVтАЛ gives P=V(RVтАЛ)=RV2тАЛ.
Electric power is measured in Watts (W).
These formulas apply specifically to purely resistive circuits obeying Ohm's Law.
The relation P=IR is dimensionally incorrect for power.
Calculating power consumption of household appliances.
Determining appropriate fuse ratings for electrical circuits.
The equation V=IR is Ohm's Law, not a power formula.
Option D is the incorrect relation and therefore the correct answer for this 'NOT' question.
D is correct тАФ The equation P=IR is dimensionally incorrect and is not a valid relation for electric power.
Always verify the dimensional consistency of formulas; power must have units of Watts (J/s or VтЛЕA), while IтЛЕR has units of Volts.