Join 60,000+ competitive exam aspirants
Single bus-bar arrangement in substations is used for voltage is less than............
11 kV
33 kV
132 kV
220 kV
33 kV
The single bus-bar arrangement is the simplest substation configuration consisting of a single main bus to which all incoming and outgoing circuits are connected. Due to its lack of redundancy, it is typically restricted to low-voltage distribution systems where supply continuity requirements are less stringent, generally up to 33 kV.
The single bus-bar arrangement is the simplest substation configuration consisting of a single main bus to which all incoming and outgoing circuits are connected. Due to its lack of redundancy, it is typically restricted to low-voltage distribution systems where supply continuity requirements are less stringent, generally up to 33 kV.
VopтАЛтЙд33┬аkV тАФ Operating limit for single bus-bar system
C=тИСi=1nтАЛCiтАЛ тАФ Total installation cost approximation
In this arrangement, all feeder circuits and transformer banks are connected to a single common bus. If a fault occurs on the bus-bar itself, the entire supply is interrupted, leading to a complete outage. Because maintenance on the bus requires de-energizing the entire system, its use is limited to smaller substations where operational downtime can be managed or alternative supply paths are not critical.
Simplest and most economical design for substation bus-bar configuration.
Major disadvantage: Lack of flexibility; any fault on the bus requires complete shutdown.
Maintenance of circuit breakers or bus-bar leads to interruption of supply to all connected loads.
Commonly used in small distribution substations and rural electrification.
Low initial installation cost.
Minimum number of switchgear and equipment required.
Simple operation and control.
Smallest physical footprint.
No flexibility for expansion or maintenance.
Total supply failure occurs during bus-bar faults.
Maintenance of any breaker/bus component requires shutdown.
Reliability is low compared to double bus-bar systems.
Small distribution substations.
Rural electrical networks.
Secondary substations in industrial plants.
For voltages higher than 33 kV, configurations like double bus-bar or breaker-and-a-half schemes are preferred to ensure reliability.
The 11 kV option is technically correct as a range limit, but 33 kV is the established industrial standard ceiling for this specific configuration.
B is correct тАФ Single bus-bar arrangements are generally limited to systems operating below 33 kV due to the lack of redundancy and maintenance flexibility.
Always remember: Complexity in bus-bar design is directly proportional to voltage level and reliability requirements. Higher voltages (>66kV) almost always utilize double bus-bar or ring bus arrangements.