Join 60,000+ competitive exam aspirants
Steam pressure used in steam power plants in India is in the range of
110 – 170 kg/cm²
40 – 80 kg/cm²
20 – 40 kg/cm²
250 kg/cm²
110 – 170 kg/cm²
In Indian thermal power plants, the steam pressure for subcritical units typically ranges from 110 kg/cm² to 170 kg/cm². Higher pressures are preferred to increase the thermal efficiency of the Rankine cycle, although they are constrained by metallurgical limits of boiler tubes.
In Indian thermal power plants, the steam pressure for subcritical units typically ranges from 110 kg/cm² to 170 kg/cm². Higher pressures are preferred to increase the thermal efficiency of the Rankine cycle, although they are constrained by metallurgical limits of boiler tubes.
ηthermal=QinWnet — Thermal efficiency of the power plant
Pcritical≈221.2 bar — Thermodynamic limit for subcritical steam generation
The steam power plant operates on the Rankine cycle. According to the efficiency formula, η=1−THTL, higher steam pressures allow the boiler to operate at higher average temperatures during the heat addition phase. Increasing the pressure elevates the saturation temperature, thereby shifting the cycle closer to the Carnot efficiency limit.
Most conventional coal-fired plants in India operate in the subcritical range.
Supercritical plants operate at pressures above 221.2 kg/cm² (typically ~246 kg/cm²).
Increased pressure reduces the specific steam consumption (kg/kWh).
Higher cycle efficiency
Reduced fuel consumption per unit of power
Smaller plant footprint for same power output
Higher capital cost for high-pressure boilers
Requirement for advanced high-strength alloys
Increased risk of boiler tube failures
Utility scale thermal power generation
Base load power stations
Subcritical units: 110 - 170 kg/cm².
Supercritical units: > 225 kg/cm².
Option B and C are too low for modern utility power plants, and option D represents the threshold for supercritical operation.
A is correct — The standard operating pressure for subcritical steam power plants in India is between 110 and 170 kg/cm².
Always distinguish between subcritical and supercritical parameters; supercritical plants operate above the critical pressure of water (221.2 bar/225.6 kg/cm²).