Join 60,000+ competitive exam aspirants
The cross sectional area of the neutral wire in a three wire DC distribution system is usually
Same as that of outer
One half of that of outer
One fourth of that of outer
Double of that of outer
One half of that of outer
In a 3-wire DC distribution system, the neutral wire is designed to carry only the out-of-balance current between the two outer wires. Since the neutral current is typically much smaller than the current in the outer wires, its cross-sectional area is kept significantly smaller, usually taken as half of the outer conductor's area.
In a 3-wire DC distribution system, the neutral wire is designed to carry only the out-of-balance current between the two outer wires. Since the neutral current is typically much smaller than the current in the outer wires, its cross-sectional area is kept significantly smaller, usually taken as half of the outer conductor's area.
InтАЛ=I1тАЛтИТI2тАЛ тАФ Neutral current in 3-wire DC system
AnтАЛтЙИ21тАЛAoтАЛ тАФ Relative cross-sectional area relation
The 3-wire DC system uses two outer conductors at a potential of V each with respect to the neutral, providing a system voltage of 2V. If the loads on the two sides are perfectly balanced, the neutral current InтАЛ=0. If loads are unbalanced, InтАЛ=I1тАЛтИТI2тАЛ, which is significantly lower than the full load current of the outer wires, justifying the use of a smaller cross-section for the neutral to save copper costs.
The neutral wire acts as a mid-point reference.
Copper saving is achieved by reducing neutral wire size.
Under balanced conditions, no current flows in the neutral.
The 3-wire system provides both V and 2V supply levels.
Increased transmission efficiency due to higher distribution voltage.
Significant saving in conductor material (copper).
Requires a balancing mechanism at the substation.
System complexity is higher than a 2-wire DC system.
Historically used in DC tramway systems.
Early municipal DC power distribution networks.
If the neutral wire were the same size as the outer wires, the economic benefit of the 3-wire DC system over the 2-wire system would be minimized.
Standard practice in engineering design manuals is to select the neutral wire cross-section based on the expected maximum unbalanced current.
B is correct тАФ The neutral wire is sized at one-half the cross-section of the outer conductors because it only carries the differential load current.
Always remember that in electrical design, wire sizing is determined by both the current-carrying capacity (ampacity) and voltage drop constraints; for the neutral in a 3-wire DC system, the ampacity requirement is reduced.