Join 60,000+ competitive exam aspirants
The governing employed for medium and larger sized steam turbine is
Bypass
Nozzle
Throttle
Combination of (b) and (c)
Nozzle
Nozzle governing is the standard method for medium and large-sized steam turbines, where steam is supplied to the turbine through multiple nozzle groups. By opening or closing these nozzle groups in sequence, the mass flow rate of steam is varied to maintain the turbine speed under different load conditions.
Nozzle governing is the standard method for medium and large-sized steam turbines, where steam is supplied to the turbine through multiple nozzle groups. By opening or closing these nozzle groups in sequence, the mass flow rate of steam is varied to maintain the turbine speed under different load conditions.
PтЙИKтЛЕm╦Щ тАФ Relation between Power and steam mass flow
╬╖nozzleтАЛ>╬╖throttleтАЛ тАФ Comparative efficiency at partial loads
In nozzle governing, the steam chest is divided into several compartments, each feeding a specific group of nozzles. As the load increases, more nozzle groups are opened to allow greater steam mass flow, while at lower loads, these groups are shut off. This reduces the throttling losses associated with purely throttle-governed systems by maintaining higher pressure at the nozzle entry point, thus achieving better efficiency at partial loads.
Used extensively in large capacity utility power plants.
Minimizes throttling losses by avoiding the pressure reduction across a single valve.
Requires complex valve mechanisms compared to throttle governing.
Maintains high steam pressure at the inlet of individual nozzle segments.
High efficiency at partial loads
Reduced throttling losses
Complex valve operating mechanism
Higher initial capital cost
Utility scale thermal power plants
Large industrial steam turbines
| Feature | Nozzle Governing | Throttle Governing |
|---|---|---|
Efficiency | High at partial loads | Low at partial loads |
Complexity | High | Low |
Throttle governing is typically preferred for smaller turbines due to its simplicity.
Bypass governing is used for large turbines during specific start-up conditions or to protect the turbine from overheating.
B is correct тАФ Nozzle governing is preferred for larger turbines as it maintains higher efficiency by minimizing throttling losses across the valve stages.
In engineering exams, always associate 'Throttle Governing' with simplicity and small/medium loads, and 'Nozzle Governing' with efficiency and high-capacity large turbines.