Join 60,000+ competitive exam aspirants
The ratio of exit pressure to inlet pressure of maximum mass flow rate per unit area of steam through a nozzle, when the steam is initially super heated is
0.650
0.578
0.545
0.532
0.545
The maximum mass flow rate per unit area (choked flow) in a steam nozzle occurs when the nozzle exit pressure reaches a critical pressure ratio. For superheated steam, which behaves approximately like an ideal gas with an isentropic index (╬│ or n) of approximately 1.3, this ratio is given by P1тАЛP2тАЛтАЛ=(n+12тАЛ)nтИТ1nтАЛ.
The maximum mass flow rate per unit area (choked flow) in a steam nozzle occurs when the nozzle exit pressure reaches a critical pressure ratio. For superheated steam, which behaves approximately like an ideal gas with an isentropic index (╬│ or n) of approximately 1.3, this ratio is given by P1тАЛP2тАЛтАЛ=(n+12тАЛ)nтИТ1nтАЛ.
P1тАЛPcтАЛтАЛ=(n+12тАЛ)nтИТ1nтАЛ тАФ Critical pressure ratio formula for compressible flow
nтЙИ1.3 тАФ Isentropic index for superheated steam
When steam expands through a converging-diverging nozzle, the mass flow rate increases as the exit pressure decreases until the velocity at the throat reaches the local sonic velocity. At this 'choked' condition, further reduction in back pressure does not increase the mass flow rate. For superheated steam with nтЙИ1.3, substituting the value into the critical pressure formula yields a ratio of approximately 0.545.
The phenomenon is known as 'Choked Flow' or 'Critical Flow'.
The ratio depends on the isentropic index (n or ╬│) of the fluid.
For saturated steam, the value is approximately 0.577 or 0.58.
For air (diatomic gas), the ratio is 0.528 as n=1.4.
Allows for calculation of maximum steam discharge capacity.
Essential for designing nozzle geometry in turbines.
Steam turbine design
Safety relief valve sizing
Nozzle and diffuser flow analysis
Option B (0.578) is typically associated with saturated steam where nтЙИ1.135.
Option D (0.532) is closer to the value for a perfect gas with ╬│=1.4 (approx 0.528).
C is correct тАФ The critical pressure ratio for superheated steam is approximately 0.545, derived from the isentropic expansion relation using an index of 1.3.
Always check the state of the steam (saturated vs superheated) as it changes the isentropic index (n) and consequently the critical pressure ratio.