Join 60,000+ competitive exam aspirants
The power for a purely resistive circuit is zero when?
Current is zero
Voltage is zero
Both current and voltage are zero
Either current or voltage is zero
Either current or voltage is zero
In a purely resistive circuit, the instantaneous power p(t) is the product of instantaneous voltage v(t) and instantaneous current i(t). Since p(t)=v(t)├Чi(t), the power becomes zero if either the voltage or the current is zero at any given instant.
In a purely resistive circuit, the instantaneous power p(t) is the product of instantaneous voltage v(t) and instantaneous current i(t). Since p(t)=v(t)├Чi(t), the power becomes zero if either the voltage or the current is zero at any given instant.
p(t)=v(t)тЛЕi(t) тАФ Instantaneous power formula
p(t)=i2(t)тЛЕR тАФ Power in terms of current and resistance
According to Ohm's Law for a resistor, v(t)=i(t)├ЧR. If the current i(t) is zero, the voltage v(t) must also be zero, and conversely, if the voltage v(t) is zero, the current i(t) must be zero. Therefore, power p=0 occurs at the zero-crossing points of the sinusoidal waveforms in AC circuits or when the circuit is open-circuited.
Power in a resistor is always non-negative because v and i are in phase.
The product is zero only when one of the factors is zero.
For sinusoidal AC, power reaches zero twice per cycle at the zero-crossing points.
Resistors dissipate energy as heat linearly.
No phase shift between voltage and current in purely resistive loads.
Resistive circuits cannot store energy like inductors or capacitors.
Continuous power loss occurs as heat.
Heating elements
Incandescent lighting
Current limiting resistors
In a resistive circuit, v(t)=VmтАЛsin(╧Йt) and i(t)=ImтАЛsin(╧Йt). The power p(t)=VmтАЛImтАЛsin2(╧Йt). This is zero when sin(╧Йt)=0.
Options A, B, and C are subsets of D; D covers the complete logical condition required for the product of two variables to be zero.
D is correct тАФ Since power p is defined as the product v├Чi, the power is zero if either the current or the voltage drops to zero.
Always remember that for any load, p=vi is valid instantaneously; the phase angle only dictates the average power over time, not the instantaneous zero condition.