Join 60,000+ competitive exam aspirants
Which of the following busbar arrangement is generally employed in distribution system?
One-and-half breaker arrangement
Main and transfer arrangement
Ring main distribution system
Single busbar arrangement system
Ring main distribution system
In electrical distribution systems, the ring main arrangement is preferred because it offers high reliability and better voltage regulation compared to radial systems. By feeding the load from both directions through a closed loop, the system ensures power continuity even if a section of the line is faulted or requires maintenance.
In electrical distribution systems, the ring main arrangement is preferred because it offers high reliability and better voltage regulation compared to radial systems. By feeding the load from both directions through a closed loop, the system ensures power continuity even if a section of the line is faulted or requires maintenance.
VdropтАЛтЙИI(Rcos╧Х+Xsin╧Х) тАФ approximated voltage drop in distribution lines
ReliabilityтИЭ1тИТ(Failure┬аRate├ЧTime) тАФ qualitative reliability concept
The ring main system consists of a closed loop or circuit fed at one or more points. Power flows from the source to the loads through multiple parallel paths. This configuration allows for the isolation of faulty sections while keeping the rest of the network energized, significantly enhancing the supply availability for consumers.
Ring main systems minimize voltage fluctuations at the consumer end.
The arrangement allows for bidirectional power flow.
Maintenance can be performed on any section without interrupting the entire supply.
Commonly used in urban areas for city-wide power distribution.
High reliability and continuous power supply
Better voltage regulation
Easy to maintain individual sections
Complex design and higher initial installation cost
Requires more sophisticated protection coordination (directional relays)
Difficult to expand compared to simple radial systems
Urban residential distribution
Industrial plant power grids
High-reliability commercial hubs
Radial distribution is the simplest but least reliable, as a single fault results in total outage for downstream consumers.
One-and-half breaker arrangements are typically restricted to EHV transmission substations, not local distribution.
C is correct тАФ The ring main distribution system provides superior redundancy and reliability by allowing power to be supplied through two alternative paths to any load point.
For competitive exams, remember: Ring Main = High Reliability; Radial = Low Cost/Low Reliability. If asked about EHV transmission systems, prioritize the 'One-and-half breaker' arrangement.