Join 60,000+ competitive exam aspirants
Which of the following contributes to the rankine efficiency improvement in a steam power plant ?
Use of high pressure
Reheat of steam at intermediate stages
Use of steam for heating of boiler feed water
All of above
All of above
The efficiency of a Rankine cycle is fundamentally governed by the temperature range of heat addition and rejection. All three methods mentionedтАФincreasing boiler pressure, implementing reheat, and using regenerative feed water heatingтАФserve to increase the average temperature at which heat is added to the cycle, thereby increasing the overall thermal efficiency.
The efficiency of a Rankine cycle is fundamentally governed by the temperature range of heat addition and rejection. All three methods mentionedтАФincreasing boiler pressure, implementing reheat, and using regenerative feed water heatingтАФserve to increase the average temperature at which heat is added to the cycle, thereby increasing the overall thermal efficiency.
╬╖rankineтАЛ=1тИТQinтАЛQoutтАЛтАЛ
╬╖carnotтАЛ=1тИТTHтАЛTLтАЛтАЛ
1. Increasing Boiler Pressure: Raises the saturation temperature, shifting the heat addition process to a higher temperature level. 2. Reheating: Prevents excessive moisture at the turbine exhaust while allowing for higher average expansion temperatures. 3. Regenerative Feed Heating: Uses extracted steam to preheat feed water, reducing the heat input required from the fuel for the initial heating phase, thus improving the thermal efficiency.
Increasing boiler pressure elevates the heat addition temperature but requires stronger boiler materials.
Reheating increases the work output per kg of steam and reduces moisture content in low-pressure stages.
Regeneration improves the thermal efficiency by reducing the irreversibility during the heat exchange between feed water and combustion gases.
Total efficiency improvement is limited by metallurgical constraints of turbine blades and boiler tubes.
Higher thermal efficiency
Reduced fuel consumption
Lower moisture content at turbine exhaust (with reheat)
Increased capital cost due to complex auxiliary equipment
Maintenance complexity
Metallurgical limitations at ultra-high pressures
Thermal power plants
Cogeneration systems
Nuclear power plants
The use of regenerative feed water heating is the most effective method for practical efficiency gains in modern power plants.
Reheating specifically targets the exit quality of the steam, protecting the turbine blades from erosion caused by moisture droplets.
D is correct тАФ all the listed methods are standard engineering techniques to enhance the thermal efficiency of a steam power plant by optimizing the heat addition and heat rejection processes.
Always remember that increasing the area under the T-s diagram during heat addition is the primary goal for improving thermal efficiency in any power cycle.