Join 60,000+ competitive exam aspirants
Which of the following plants can never have 100 per cent load factor?
Nuclear power plant
Hydro electric power plant
Base load plant
Peak load plant
Peak load plant
A peak load power plant is specifically designed to operate only during periods of high consumer demand. Because it remains idle or in a standby state for a significant portion of the day, it is physically and economically impossible for it to achieve a 100% load factor.
A peak load power plant is specifically designed to operate only during periods of high consumer demand. Because it remains idle or in a standby state for a significant portion of the day, it is physically and economically impossible for it to achieve a 100% load factor.
Load┬аFactor=MaximumDemandAverageLoadтАЛ
UnitsGenerated┬а(kWh)=MaxDemand├ЧLoadFactor├ЧHours
Load factor is defined as the ratio of average load to the maximum demand over a specific period. A 100% load factor implies the plant operates at its maximum rated capacity continuously (24/7). Peak load plants (e.g., Gas Turbine or Pumped Hydro) are intended to meet short-duration spikes in demand; thus, their output fluctuates and drops to zero or near-zero outside of peak hours, resulting in a low load factor.
Load factor is always less than unity (1) for practical power systems.
Base load plants (Nuclear, Run-of-river Hydro) have high load factors (> 70-80%).
Peak load plants have low load factors because they are idle during off-peak hours.
A 100% load factor represents a perfectly constant load curve.
Peak plants reduce the burden on base load plants.
Peak plants provide rapid response to frequency fluctuations.
Peak plants have higher cost per unit of electricity generated.
Frequent startup/shutdown of peak plants increases maintenance costs.
Pumped storage hydro plants.
Gas turbine open-cycle power plants.
| Feature | Base Load Plant | Peak Load Plant |
|---|---|---|
Operation Purpose | Continuous constant supply | Meeting short-term surges |
Nuclear plants are quintessential base load plants due to their high capital cost and inability to vary output quickly.
Run-of-river hydro plants are typically base load if water flow is perennial.
D is correct тАФ Peak load plants are explicitly operated for short durations during high demand, making continuous 100% utilization impossible.
In competitive exams, remember that any plant described as 'Peak Load' is mathematically constrained to have a Load Factor significantly less than 1.0.