Join 60,000+ competitive exam aspirants
Why the armature of DC machine is laminated.
to reduce the mass
to reduce the inductor
to reduce the eddy current loss
to reduce the hysteresis loss
to reduce the eddy current loss
The armature core of a DC machine is laminated to minimize the circulation of eddy currents within the iron core. By splitting the core into thin, insulated sheets, the path length for these currents increases while their effective area decreases, significantly reducing power loss and heat generation.
The armature core of a DC machine is laminated to minimize the circulation of eddy currents within the iron core. By splitting the core into thin, insulated sheets, the path length for these currents increases while their effective area decreases, significantly reducing power loss and heat generation.
PeтАЛ=KeтАЛBm2тАЛf2t2V тАФ eddy current loss formula where t is lamination thickness
ReddyтАЛтИЭ╧БAlтАЛ тАФ resistance path for eddy currents increased by lamination
According to Faraday's law of induction, the rotating armature core experiences a changing magnetic flux, which induces an EMF within the iron material. If the core were a solid block, this low-resistance path would allow large circular eddy currents (Foucault currents) to flow, leading to PeтАЛ=KeтАЛBm2тАЛf2t2V losses. Lamination effectively inserts high-resistance barriers perpendicular to these current paths, suppressing their magnitude.
Eddy currents are circulating currents induced in the core by changing magnetic flux.
Lamination increases the resistance of the path for eddy currents, limiting their magnitude.
The sheets are coated with varnish or oxide layer to provide electrical insulation between them.
Eddy current loss is proportional to the square of the lamination thickness (t2).
Reduction in heat dissipation within the armature core.
Improvement in overall machine efficiency.
Prevention of localized hotspots that could damage insulation.
Increased complexity in manufacturing the armature.
Slight reduction in the stacking factor (magnetic material volume versus total volume).
DC Motors
DC Generators
Transformers
AC Induction Motors
Armature cores are typically made of silicon steel to also reduce hysteresis losses, but lamination specifically targets eddy current reduction.
Option D is incorrect because hysteresis loss is minimized by choosing materials with a narrow B-H loop, not by lamination.
C is correct тАФ Lamination is specifically employed to increase the electrical resistance path within the core to reduce eddy current magnitude.
Remember that while lamination reduces eddy current losses, silicon steel alloying is used to reduce hysteresis losses (proportional to frequency f). Both are vital for core design.