Join 60,000+ competitive exam aspirants
For a consumer the most economical power factor is usually
0.25 to 0.5 lagging
0.25 to 0.5 leading
0.85 to 0.95 lagging
0.85 to 0.95 leading
0.85 to 0.95 lagging
The most economical power factor for a consumer typically falls in the range of 0.85 to 0.95 lagging. Operating below this range leads to higher line losses and penalty charges from utilities, while exceeding this range incurs high costs for power factor correction equipment (e.g., capacitor banks) that outweigh the savings.
The most economical power factor for a consumer typically falls in the range of 0.85 to 0.95 lagging. Operating below this range leads to higher line losses and penalty charges from utilities, while exceeding this range incurs high costs for power factor correction equipment (e.g., capacitor banks) that outweigh the savings.
PF=cos(╧Х)=SPтАЛ тАФ definition of power factor as ratio of real power to apparent power
KVARreqтАЛ=P(tan(╧Х1тАЛ)тИТtan(╧Х2тАЛ)) тАФ capacity required to improve power factor from cos(╧Х1тАЛ) to cos(╧Х2тАЛ)
The total cost of electricity supply is a function of fixed charges (penalties for low power factor) and variable costs (cost of capacitors). As power factor increases, the KVA demand decreases, reducing utility bills, but the cost of the compensation hardware increases non-linearly. The optimal point is where the sum of these costs is minimized.
Most industrial loads are inductive, requiring lagging power factor correction.
Utility providers often impose penalties for power factor below 0.85 or 0.90.
Over-correction leads to a leading power factor, which can cause voltage rises and potential resonance issues.
The 'economical' value balances the cost of electricity billing vs. the cost of capacitor investment.
Reduced copper losses (I2R losses) in conductors
Increased effective capacity of transformers and switchgear
Better voltage regulation at the load end
Avoidance of utility penalty charges
Initial capital investment required for capacitor banks
Possible resonance if harmonics are present in the system
Risk of over-correction leading to leading power factor
Industrial motor installations
Commercial buildings with HVAC systems
Distribution substations
While 1.0 is technically the 'ideal' power factor regarding efficiency, it is not 'economical' due to the diminishing returns and high cost of compensation equipment required to bridge the gap from 0.95 to 1.0.
Options A and B represent values that are physically inefficient and would lead to severe economic penalties.
C is correct тАФ the range of 0.85 to 0.95 lagging provides the best trade-off between reduction in electricity bills and the investment cost of power factor correction equipment.
Always remember that in competitive exams, 'economical' refers to the minimum total cost, not the peak technical performance (which would be unity PF).