Join 60,000+ competitive exam aspirants
For starting a DC motor a starter is required because
it limits the starting current
It starts the motor
it limits the speed of the motor
None of the above
it limits the starting current
A DC motor starter is required to limit the high armature current during the starting phase when the back EMF is zero. Since the armature resistance is very low, the absence of back EMF would cause a massive inrush current, potentially damaging the motor windings.
A DC motor starter is required to limit the high armature current during the starting phase when the back EMF is zero. Since the armature resistance is very low, the absence of back EMF would cause a massive inrush current, potentially damaging the motor windings.
IaтАЛ=RaтАЛVтИТEbтАЛтАЛ тАФ Armature current equation
EbтАЛ=60AP╬жNZтАЛ тАФ Back EMF of a DC motor
When a DC motor is at standstill, the speed ╧Й=0, leading to zero back EMF (EbтАЛ=0). According to the armature current equation IaтАЛ=RaтАЛVтИТEbтАЛтАЛ, the current becomes very high because RaтАЛ is negligible. The starter introduces external resistance in series with the armature to keep IaтАЛ within safe limits until the motor gains speed and generates enough back EMF.
Back EMF (EbтАЛ) is directly proportional to speed (N).
At standstill, N=0 and EbтАЛ=0.
Starters reduce the starting voltage or increase resistance to protect the armature.
Three-point and Four-point starters are common types used for DC shunt motors.
Protects motor windings from overheating
Prevents damage to the commutator and brushes
Prevents voltage sag in the supply lines
Adds cost and complexity to the motor starting system
Energy is dissipated as heat in the starting resistor
DC Shunt Motors
DC Compound Motors
The internal resistance of the armature (RaтАЛ) is typically very small (less than 1 ohm).
Option B is incorrect because starters do not 'start' the motor in the sense of providing torque; they only protect it during the start-up sequence.
Option C is incorrect because starters are used only during the starting period, not for continuous speed control.
A is correct тАФ The starter provides an external resistance in series with the armature to restrict the inrush of current when the back EMF is zero.
Remember that DC series motors should never be started without a load, as they can reach dangerously high speeds (runaway speed).