Join 60,000+ competitive exam aspirants
In a gas turbine power plant, a regenerator increases the
Pressure ratio
Work output
Thermal efficiency
Fuel consumption of the plant
Thermal efficiency
A regenerator in a gas turbine cycle is a heat exchanger that transfers heat from the exhaust gases to the compressed air before it enters the combustion chamber. By utilizing waste heat from the turbine exhaust to preheat the intake air, it reduces the amount of external fuel required to reach the target turbine inlet temperature, thereby improving the cycle's thermal efficiency.
A regenerator in a gas turbine cycle is a heat exchanger that transfers heat from the exhaust gases to the compressed air before it enters the combustion chamber. By utilizing waste heat from the turbine exhaust to preheat the intake air, it reduces the amount of external fuel required to reach the target turbine inlet temperature, thereby improving the cycle's thermal efficiency.
╬╖regenтАЛ=hturbineeтАЛxhaustтАЛтИТhcompressediтАЛnтАЛhexhaustoтАЛutтАЛтИТhcompressediтАЛnтАЛтАЛ тАФ Regenerator Effectiveness
╬╖thтАЛ=1тИТQinтАЛQoutтАЛтАЛ тАФ Thermal Efficiency
The compressor increases air pressure, and in a simple cycle, this air goes directly to the combustor. With a regenerator, the exhaust gases (which are at a high temperature) pass through one side of the heat exchanger while the compressed air passes through the other. This process recovers heat that would otherwise be rejected to the atmosphere, effectively reducing the heat input requirement for the same work output.
A regenerator increases the thermal efficiency by reducing heat input QinтАЛ.
It is most effective at low pressure ratios.
It does not change the net work output of the turbine-compressor system.
Regeneration reduces fuel consumption for the same power output.
Significant improvement in thermal efficiency
Reduced fuel consumption and operational cost
Increases the physical size and weight of the plant
Adds pressure drop across the heat exchanger, which can limit efficiency gains
Gas turbine power plants
Marine propulsion systems
Combined heat and power (CHP) installations
The net work output remains unchanged because the regenerator does not interact with the turbine expansion or compressor compression work.
Option A is incorrect because the pressure ratio is a design parameter determined by the compressor/turbine.
Option D is partially true as a byproduct, but the primary thermodynamic objective is the increase in thermal efficiency.
C is correct тАФ A regenerator improves the thermal efficiency of a gas turbine cycle by preheating the compressed air using exhaust heat, thereby decreasing the required fuel input.
Always remember that regeneration improves efficiency at the cost of additional complexity and pressure drop; it is essentially a method for heat recovery.