Join 60,000+ competitive exam aspirants
In a regenerative cycle, feed water is heated by
Heaters
Drained steam from the turbine
Exhaust gases
All of above
Drained steam from the turbine
In a regenerative steam cycle, a portion of the steam is extracted from the turbine at various stages to preheat the feedwater. This process, known as feedwater heating, increases the average temperature at which heat is added to the cycle, thereby improving the overall thermal efficiency of the Rankine cycle.
In a regenerative steam cycle, a portion of the steam is extracted from the turbine at various stages to preheat the feedwater. This process, known as feedwater heating, increases the average temperature at which heat is added to the cycle, thereby improving the overall thermal efficiency of the Rankine cycle.
╬╖regenтАЛ>╬╖RankineтАЛ тАФ Efficiency comparison
QinтАЛ=m╦Щ(hboilerтАЛтИТhfeedтАЛ) тАФ Heat input to boiler
Steam is bled (extracted) from the turbine before it reaches the condenser. This steam passes through a heat exchanger (regenerative heater) where it gives up its latent heat to the relatively cold feedwater being pumped toward the boiler. By reducing the temperature difference between the heating fluid and the working fluid, the entropy production is minimized, pushing the cycle closer to the ideal Carnot efficiency.
Reduces the amount of heat required from the boiler for a given power output.
Improves the mean temperature of heat addition.
Uses regenerative heaters (Open or Closed type).
Does not significantly change the specific work output but increases thermal efficiency.
Increases cycle thermal efficiency.
Reduces thermal stress in the boiler due to higher feedwater temperature.
Improves turbine blade life by reducing moisture at exit stages.
Increases plant complexity and capital cost.
Reduces total mass flow through the low-pressure turbine stages.
Large-scale fossil fuel power plants.
Nuclear power generation cycles.
Option C (Exhaust gases) is typically used for Economizers or Air Preheaters in the flue gas path, not strictly as the working fluid in the regenerative cycle itself.
Regeneration effectively keeps the cycle closer to the reversible isothermal heat addition process.
B is correct тАФ In a regenerative cycle, steam is bled from the turbine to heat the incoming feedwater, thereby increasing thermal efficiency.
Always remember that regeneration in steam cycles targets the mean temperature of heat addition, whereas intercooling in gas cycles targets the mean temperature of heat rejection.