Join 60,000+ competitive exam aspirants
Reheat cycle in a steam power station is employed for
Improving thermal efficiency
Improving condenser performance
Reducing heat losses
Utilizing heat of flue gases
Improving thermal efficiency
The reheat cycle in a steam power plant is primarily employed to increase the thermal efficiency of the Rankine cycle. It involves extracting steam from the high-pressure turbine, reheating it in the boiler to the initial inlet temperature, and then expanding it through the low-pressure turbine.
The reheat cycle in a steam power plant is primarily employed to increase the thermal efficiency of the Rankine cycle. It involves extracting steam from the high-pressure turbine, reheating it in the boiler to the initial inlet temperature, and then expanding it through the low-pressure turbine.
╬╖thermalтАЛ=1тИТqinтАЛqoutтАЛтАЛ тАФ basic thermal efficiency definition
╬ФTmeanтАЛ=QinтАЛтИлTdQтАЛ тАФ effective mean temperature of heat addition
By reheating the steam, the moisture content at the exit of the low-pressure turbine is significantly reduced, which prevents turbine blade erosion. This process allows the mean temperature of heat addition to increase, thereby improving the cycle's thermal efficiency according to the Carnot principle (EfficiencyтИЭ1тИТTmeanaтАЛddтАЛTminтАЛтАЛ).
Reheating increases the quality of steam at the exhaust of the low-pressure turbine.
It helps in minimizing the risk of erosion of turbine blades due to moisture impact.
It generally results in an increase in thermal efficiency by about 2-3%.
The process involves an additional heat exchanger (reheater) within the boiler.
Improvement in thermal efficiency
Reduction of moisture content in final turbine stages
Increased turbine work output
Increased capital cost due to extra piping and reheater
Complex plant control system
Increased maintenance requirement
High-capacity thermal power stations
Modern supercritical steam power plants
Option B is incorrect because condenser performance is largely independent of reheating; it is affected by cooling water temperature and vacuum conditions.
Option D is related to economizers or air preheaters, which utilize flue gases to preheat feed water or combustion air, rather than reheating turbine steam.
A is correct тАФ Reheat cycle is employed to enhance the thermal efficiency of steam power plants and reduce turbine blade erosion by increasing the steam quality at exhaust.
Always remember that reheat is for efficiency and steam quality, while regeneration (feedwater heating) is for improving the average temperature of heat addition without increasing moisture content.