Join 60,000+ competitive exam aspirants
In a regenerative surface condenser
There is no pump to remove condensate and the condensate gets removed by gravity
There is only one pump for removing air and condensate
There are two pumps for removing air and condensate
There are three pumps to remove air, condensate and vapour
There are two pumps for removing air and condensate
A regenerative surface condenser is designed to recover heat by heating the feed water using extracted steam. Because air and non-condensable gases inhibit heat transfer and condensate requires removal for cycle continuity, it utilizes two distinct pumps: an air extraction pump to maintain vacuum and a condensate extraction pump to return water to the feed circuit.
A regenerative surface condenser is designed to recover heat by heating the feed water using extracted steam. Because air and non-condensable gases inhibit heat transfer and condensate requires removal for cycle continuity, it utilizes two distinct pumps: an air extraction pump to maintain vacuum and a condensate extraction pump to return water to the feed circuit.
PtotalтАЛ=PsteamтАЛ+PairтАЛ тАФ Dalton's Law applied to the condenser vacuum
m╦ЩcтАЛ=hfgтАЛQтАЛ тАФ Mass flow rate of condensate related to heat rejection
The condenser maintains a high vacuum to maximize enthalpy drop. Air enters through leakage or feed water, requiring an extraction pump to prevent partial pressure increase. Simultaneously, the condensate, which collects at the bottom of the hotwell, must be pumped out against the pressure difference to the feed water heating system.
Regeneration improves the overall thermal efficiency of the Rankine cycle.
Air extraction is critical because even small amounts of air significantly lower the heat transfer coefficient (h).
The condenser hotwell provides a residence time for deaeration.
Increased cycle thermal efficiency.
Effective deaeration of feed water reduces boiler corrosion.
Increased complexity of auxiliary equipment.
Higher initial capital cost due to multiple pump requirements.
Large-scale thermal power plants.
Marine steam propulsion systems.
The condensate extraction pump is typically a centrifugal pump designed to handle water at saturation temperature.
Air pumps are often steam jet ejectors or liquid ring vacuum pumps.
C is correct тАФ Regenerative surface condensers utilize separate pumps to handle the removal of non-condensable air and the extraction of liquid condensate to maintain optimal vacuum and cycle flow.
Always remember that in steam power plants, any system component that handles phase change (like a condenser) must account for both the liquid phase and the non-condensable gas phase separately to maintain steady-state operation.