Join 60,000+ competitive exam aspirants
In a thermal power plant, the feed water coming to the economizer is heated using
HP steam
LP steam
Direct heat in the furnace
Flue gases
Flue gases
An economizer in a thermal power plant is a heat exchange device that recovers waste heat from the outgoing flue gases. It uses this energy to preheat the feedwater before it enters the boiler, thereby increasing the overall thermal efficiency of the plant.
An economizer in a thermal power plant is a heat exchange device that recovers waste heat from the outgoing flue gases. It uses this energy to preheat the feedwater before it enters the boiler, thereby increasing the overall thermal efficiency of the plant.
Q=m╦ЩfwтАЛcp,fwтАЛ(ToutтАЛтИТTinтАЛ) тАФ Heat energy gained by feedwater
╬╖effтАЛ=QfuelтАЛQactualтАЛтАЛ тАФ Increase in plant efficiency
The flue gases, which are at a high temperature after leaving the superheater, are passed through the economizer coils. As these gases flow over the pipes carrying feedwater to the boiler, heat transfer occurs via convection and conduction. This raises the feedwater temperature, reducing the amount of fuel required in the boiler to generate steam.
Economizers are placed in the path of flue gases between the boiler outlet and the air preheater.
It prevents thermal shock in the boiler by reducing the temperature difference between incoming water and boiler metal.
The use of an economizer typically improves plant efficiency by 5-10%.
Increases overall plant thermal efficiency
Reduces fuel consumption
Minimizes thermal stress on boiler drums
Increases cost and complexity of the plant
Potential for flue gas side corrosion if temperature falls below dew point
Increases pressure drop in flue gas path
Thermal power plants
Large industrial boilers
Marine steam plants
Option A and B are incorrect because HP/LP steam is typically used in feedwater heaters (regenerative cycle) located in the condensate extraction path, not in the economizer.
Option C is incorrect as the furnace is for primary fuel combustion and steam generation, not for pre-heating feedwater via exhaust gases.
D is correct тАФ The economizer utilizes the high-temperature flue gases exiting the boiler to preheat the feedwater.
Always remember that 'Regenerative Heating' uses steam from turbines, whereas 'Economizers' and 'Air Preheaters' use waste flue gases for heat recovery.