Join 60,000+ competitive exam aspirants
Insulated surface coating of a laminated sheet in the core of transformer helps to reduce
Eddy current loss
Hysteresis loss
Both Eddy current and Hysteresis losses.
none of the above.
Eddy current loss
Laminating the transformer core and applying an insulating coating (like varnish) increases the resistance path for eddy currents. This effectively breaks the circuit for induced current loops that would otherwise circulate within the core due to Faraday's Law of Induction.
Laminating the transformer core and applying an insulating coating (like varnish) increases the resistance path for eddy currents. This effectively breaks the circuit for induced current loops that would otherwise circulate within the core due to Faraday's Law of Induction.
PeтАЛ=KeтАЛBmax2тАЛf2t2V тАФ where PeтАЛ is the eddy current loss, BmaxтАЛ is peak flux density, f is frequency, and t is lamination thickness.
RpathтАЛ=╧БAlтАЛ тАФ where increasing the path resistance through insulation decreases circulating current.
According to Lenz's Law, changing magnetic flux induces an EMF in the conducting core. By slicing the core into thin insulated sheets (laminations), the cross-sectional area perpendicular to the flux is reduced, and the ohmic resistance of the paths is significantly increased. Since the power dissipated is proportional to the square of the current, minimizing these paths drastically reduces the heat loss.
Eddy currents are circulating currents induced in the conductive material of the core by alternating magnetic flux.
Lamination thickness is kept extremely thin (typically 0.2 mm to 0.5 mm) to minimize the t2 factor in loss calculations.
The core material is usually silicon steel to reduce both hysteresis and eddy current losses.
Significantly reduces core heating.
Improves transformer efficiency.
Prevents insulation degradation due to overheating.
Increases manufacturing complexity and cost.
Reduces the effective magnetic cross-section (stacking factor is less than 1).
Power transformers
Distribution transformers
Induction motors and generators
Option B (Hysteresis loss) is reduced by using materials with narrow hysteresis loops like CRGO (Cold Rolled Grain Oriented) silicon steel, not by laminating the core.
The 'Stacking Factor' represents the ratio of the actual iron cross-section to the total geometric cross-section of the core.
A is correct тАФ The insulated coating increases the electrical resistance of the flux-linking path, thereby limiting the magnitude of the circulating eddy currents.
Always remember that lamination only targets eddy current loss, whereas material selection (e.g., Silicon Steel) is used to target both hysteresis and eddy current losses.