Join 60,000+ competitive exam aspirants
Spray ponds are used for cooling warm water coming out of condenser in
Large power plants
Medium power plants
Small power plants
Both in medium and large power plants
Small power plants
Spray ponds are cooling devices where hot water from the condenser is sprayed through nozzles into the air to dissipate heat. Due to their limited cooling capacity and large space requirement, they are only efficient for small capacity power plants.
Spray ponds are cooling devices where hot water from the condenser is sprayed through nozzles into the air to dissipate heat. Due to their limited cooling capacity and large space requirement, they are only efficient for small capacity power plants.
Q=m╦ЩCpтАЛ(ThotтАЛтИТTcoldтАЛ) тАФ heat rejection rate
QevapтАЛ=m╦ЩevapтАЛhfgтАЛ тАФ latent heat transfer rate
The principle of operation is evaporative cooling. By spraying water into the atmosphere, the surface area exposed to air is drastically increased, facilitating sensible heat transfer and latent heat transfer via evaporation. The cooled water collects in a basin underneath for recirculation back to the condenser.
Primarily used in older or very small plants due to high water loss.
Operates mainly via evaporation and convection.
Requires a large land area relative to cooling towers.
Effectiveness depends significantly on ambient humidity and wind velocity.
Simple construction and low initial capital cost
Requires less maintenance than mechanical draft cooling towers
High water loss due to drift and evaporation
Requires large land area
Cooling performance is highly sensitive to prevailing weather conditions
Small thermal power stations
Captive power plants with limited cooling demand
As plant size increases, the volume of water to be cooled becomes too large for a spray pond to be physically practical, necessitating the use of natural draft or mechanical draft cooling towers.
Option A and B are incorrect because large and medium plants require more efficient, compact cooling solutions like cooling towers to manage the massive heat rejection.
C is correct тАФ Spray ponds are only suitable for small power plants due to their low cooling efficiency and high spatial footprint requirement.
Always remember that in power systems, 'Large' capacity demands compact heat exchange equipment; thus, if space is limited or load is high, prefer cooling towers over ponds.