Join 60,000+ competitive exam aspirants
Swinburne test is conducted under which of the following condition?
no load
full load
half load
any of the above
no load
The Swinburne test is a standard indirect method used to determine the efficiency of a DC machine by treating it as a shunt machine running at no-load. In this condition, the machine consumes only a small amount of power (constant losses), which allows for the accurate prediction of efficiency at any other load without requiring a full-load power source.
The Swinburne test is a standard indirect method used to determine the efficiency of a DC machine by treating it as a shunt machine running at no-load. In this condition, the machine consumes only a small amount of power (constant losses), which allows for the accurate prediction of efficiency at any other load without requiring a full-load power source.
PconstantтАЛ=VI0тАЛтИТIa2тАЛRaтАЛ тАФ Calculation of constant losses at no-load
╬╖motorтАЛ=VILтАЛVILтАЛтИТ(PconstantтАЛ+Ia2тАЛRaтАЛ)тАЛ тАФ Efficiency calculation for a motor at any load
During the test, the machine runs as a motor at rated voltage and rated speed at no-load. The total power input is measured, from which the constant losses (magnetic and mechanical losses) are calculated by subtracting the armature copper losses. Since constant losses are assumed to remain nearly constant from no-load to full-load, the efficiency at any load can be calculated mathematically.
Used only for shunt-wound DC machines.
It is an indirect method of testing, requiring minimal power.
Assumes constant losses (core and friction) are independent of load.
Not applicable to series-wound DC machines as they cannot be started on no-load.
Very economical (requires only no-load power).
Efficient and easy to perform in labs.
Allows pre-calculation of efficiency at any desired load.
Temperature rise cannot be measured (not a direct load test).
Commutation performance cannot be checked at full load.
Not suitable for series motors.
DC Shunt Motors
DC Shunt Generators
The Swinburne test is essentially a 'no-load' test that provides the foundation for separation of losses.
Option B, C, and D are incorrect because running a series machine at no-load is dangerous due to dangerously high speed, and for shunt machines, the standard protocol for this test is specifically no-load to isolate constant losses.
A is correct тАФ The Swinburne test is performed at no-load to calculate the constant losses of a DC machine by keeping the machine at rated voltage and speed.
Always remember that Swinburne is for shunt machines; for Series machines, use the Hopkinson or Field test instead.